Nice work! But why did you open the right side of the center light? On the left side you installed a rear fog light, but the right side looks original
@mtypunk
5 жыл бұрын
short answer - multiple changes of plans during the building process... i had planned full-length sequential turn signals, the fog light was supposed to be inside the reflector at the bottom edge of the bumper...but the turn signal elements got lost in transit and i really wanted to get the car on the road so i had to make the best of the situation...also tried to make fog lights symmetrical but that would have required too much cutting and soldering...
@jakublip9900
Жыл бұрын
Hi Can you tell me where to put the resistor and how to connect it brake lights?
@xsejaa
2 жыл бұрын
Nice work !
@BADMOPARCZ
4 жыл бұрын
How did you make the brake lights? They were originally combined with the turn signals, or am I wrong?
@mtypunk
4 жыл бұрын
kzitem.info/news/bejne/w2N50amtcGN4dIY converted the brake lights into amber turn signals...former tail lights(outer rings) act as tail lights and brake lights now...
@BADMOPARCZ
4 жыл бұрын
@@mtypunk Understood, but how did you do the outer rings having 2 different intensity of light?
@mtypunk
4 жыл бұрын
@@BADMOPARCZ i used resistors to dim the tail lights...
@BADMOPARCZ
4 жыл бұрын
@@mtypunk that's exactly what I taught. May I ask what value was the resistor?
@mtypunk
4 жыл бұрын
@@BADMOPARCZ huuuh, if i could just remember...high-wattage 60-100 ohm, if i had to guess...
@fabricelecolvez1698
2 жыл бұрын
thank you a lot for your vidéo, I cut my light with low prsure........Take the front signal for turn and third brake light for the brake(add relay) but I still have a problem, how to desactivate the fault sens ?
@mtypunk
2 жыл бұрын
you need to use the circuit board inside the light to power the new led's, otherwise it will trip a 'light out' message...
@adambmw0071
2 жыл бұрын
So the board from original indicator must stay inside or you mean the big one
@mtypunk
2 жыл бұрын
@@adambmw0071 you can remove the board with leds on it but have to keep the one that is mounted to the housing...
@adambmw0071
2 жыл бұрын
@@mtypunk thanks Indicator signal from board or from front indicator
Пікірлер: 20