I find it hard to believe the jack points are on the edge of the sheet metal trim panels. Im lucky to be alive I guess. I have a 2017 hyundai elantra and have always jacked it up on the passenger side underneath on the plastic molding that looks like it has a frame beam with a arrow on the plastic casing. Then put a jack stand in that same line. Been changing my own oil for 3 years now 😢😢😢
@joserosas5420
4 ай бұрын
10:30 I personally fold a red shop towel a few times and place it in between the base of the jack stand and pinch weld to help prevent it from collapsing over time. Similar idea as using the pucks on the jack stands.
@Lilpizzo
8 күн бұрын
Keep posting!!
@jessicaphoenix1312
9 ай бұрын
Who has 4 jacks?
@PaulNaylor3
9 ай бұрын
This guy 😂
@jessicaphoenix1312
9 ай бұрын
you are one of a kind, bud. @@PaulNaylor3
@PaulNaylor3
9 ай бұрын
😂
@joserosas5420
4 ай бұрын
He also has 4 floor jacks 😁👍
@showerasmr5764
4 ай бұрын
More efficient, and safe, just at a bit more expense.
@GS-xp5jq
3 ай бұрын
7:55 You should leave a little bit of space between the jack stand and floor jack. Floor jacks lift up in an arc, so the wheels and body need to be able to move freely. If the floor jack fails, there's a good chance that it'll push the jack stand too. Great video overall though. 100% agreed on how frustrating not having a center jack point is after coming from Toyota/Honda.
@PaulNaylor3
3 ай бұрын
Thanks for the advice.
@genichiroashina6372
Жыл бұрын
Are you from England? The houses are so classy and good looking.
@PaulNaylor3
Жыл бұрын
No, but I like the English accent 😃.
@BADD400
11 ай бұрын
My 2 cents is I would have bought the crossbar from Harbor freight and used the 3 ton jack and put it in between the doors and use all 4 jack stands in the proper pinch weld location. I have the same car but value edition 2.0L engine and have jacked from the middle with no issue to the pinch weld and I have had the car since new. Not saying you are wrong. Maybe easier not sure. Very good videos
@PaulNaylor3
11 ай бұрын
I did see that cross bar you are talking about and did consider it. I’m glad it works well.
@gregrice123
10 ай бұрын
What crossbar would you have purchased from HF? The only crossbar I see is for a rooftop carrier.
It appears that the crossbar needs to be used with a low profile floor jack. Is that correct? Would you need two of the hockey pucks where the crossbar pads would meet the pinch weld?
Пікірлер: 20