I have a 2019 SXT Blacktop and the rear view mirror housing is half as wide But it all worked just as this vid showed. I needed to use a screwdriver to get the small wiring connector out because the whole unit it plugs into was sliding out along with it. A small turn of a screwdriver and it came right out. Wire colors and orientation were exactly as video shows. Thanks much!!!!
@gbbbgbbb
5 жыл бұрын
Glad this was helpful.... Stay safe
@dustinsmith7919
3 жыл бұрын
Going off of this video I was able to complete my install of the blend mount for my radar detector in my charger. I have never done anything like that before. Never used a multimeter before. I just wanted to say thank you for the video. I found it extremely helpful. I had it done in about 15 min.
@gbbbgbbb
3 жыл бұрын
Awesome...glad you find this helpful and thanks for feedback. Best of luck in the future with your adding mods.
@rts159
4 жыл бұрын
where did you get the extra wires that connect to each ends ?
@slim_3923
5 жыл бұрын
Hey man did your assist or other button light up? Because I did the same and mine don’t light up or work anymore
@gbbbgbbb
5 жыл бұрын
If you're talking about the LaneSense Lane Departure Warning System, yes it worked perfectly after the install. If that is what you are referring to I would do the following. I am assuming that you might not have done these steps. First ensure that the fuse is not blown during the install. It is slot 45 - 15 Amp Blue Cluster / Rearview Mirror / Compass (Charger/300) / Humidity Sensor / Forward Facing Camera (Lane Departure) / Cyber Gateway. Also, Remember that when enabled the system operates above 37 mph and below 112 mph. Since it is easy to install the mirror tap, I would also try pulling one of the taps out and see if that fixes it, just in case there is some cross wiring that causes a short. Give these a try first.
Пікірлер: 8