I'm going to reprint in the other orientation and test again.
@terryk3118
Ай бұрын
Never would have guessed you could pull that off? What did you use for filament?
@Studebomber
Ай бұрын
Sorry for the delay in responding. I didn't see any notification. These are ASA but, big BUT, harder would be better. Good old PLA would be more rigid but u have this TPU/Nylon blend with a shore hardness of 72D. I'm going to use that to make some forming dies for a specific part. Should work well.
Пікірлер: 4