INDICE DEI VIDEO : davidesora.alte...
ENGLISH TRANSLATION of the written notes in the video, in order of appearance :
00:04 - Violin scroll part five - Roughing with saw and hacksaw
00:14 - Cut slowly and carefully to avoid damaging the scroll irreparably
00:38 - Enter at the upper part of the neck leaving intact the sides of the block, wich will be useful to be able to use the square and for tightening in the vice
01:08 - Enter at the same height on both sides, to avoid introduce asymmetry elements which could disturb the vision of the lines
01:23 - Always very careful not to touch the volute with the saw blade
01:29 - After cutting the pegbox, use a small hacksaw for the volute
01:39 - Begin by making a shallow cut along the sides of the back, keeping a clearence of about 1 mm from the circles, so as to create a reference line for the depth of subsequent cuts
02:32 - Stop at the narrowest point of the scroll without going over
02:44 - Make cuts on the front starting from the narrowest point of the scroll without going over
03:05 - Get far forward as possible, even if the cut will be subsequently finished to be able to get to the end of the volute
03:15 - Keep in mind that in this case it's curved cuts, and not straight, for which it will be necessary to change the direction of the saw blade during cutting to maintain equal distance from circles
03:46 - Put the scroll in a vice using a special block of wood protruding more than the heel, to prevent damaging it in the vise tightening
03:56 - Adjust the scroll so that it is parallel to the floor, to always have precise, intuitive reference of verticality during the cuts
04:46 - Get into the reference cut along the circles to facilitate the detachment of the waste wood pieces
05:07 - Do all cuts very out of square compared to the turn, always paying close attention not to cut undercut
05:42 - Complete the cut until the end of the volute, rising slightly from circles, before making the last cut
05:58 - Make the last cut coming at the end of the volute, being careful not to enter the mark of the turn
06:33 - Rough out hereinafter also the other side before proceeding in the working
06:48 - Always take extreme care not to accidentally cut into the volute or into the turn with the saw blade
06:57 - Remember to always cut well out of square
07:20 - Keep cutting along the circles until the end of the volute
07:28 - Make the final cut without going into the turn, but coming right at the end of the volute
08:12 - Index of videos : davidesora.alte...
08:20 - www.davidesora.it/
.
Негізгі бет 5) Testa di violino parte quinta - Sgrossatura con sega e seghetto
Пікірлер: 12