Thanks for the video. Doing this job and front bearings this weekend on our 67.
@rallycatgarageharvey1135
6 ай бұрын
I hope it was helpful. Thanks for watching.
@GreaseRookie
3 жыл бұрын
Hey Harvey. I like the intro. This was a great video. Brilliant idea with the pipe and collar. The video was very well filmed too. I can’t wait to see this thing completely painted. Good stuff! 👍
@nefishingnhunt
Жыл бұрын
My computer finally showed me the end of your video . Got the part number , very helpful . Just subscribed .
@rallycatgarageharvey1135
Жыл бұрын
Glad it was helpful!
@shogunMR
Жыл бұрын
Great video sir. You really help me out with my 1975 Ford Maverick. You save me some money and your instructions were easy to follow. 👍👍 I really appreciate it you've got a new subscriber a lot of things I'm doing to my Maverick applied to those mustangs and what working on so I really appreciate it 🙏🏼👍👍
@rallycatgarageharvey1135
Жыл бұрын
Very glad it helped!!!
@butchbuono3894
Жыл бұрын
Nice video of the process. One word of caution; it is important that you do not nick the axle with the cutoff tool (or anything else) or it may result in a leak!
@rallycatgarageharvey1135
Жыл бұрын
Great point!
@hughphillips67Mustang
3 ай бұрын
How long was the pipe you got to pass the bearing back on? 1 1/4 by ???
@nefishingnhunt
Жыл бұрын
I know your video was done a couple years ago but I have a 1969 mustang with the same 8 inch rear diff, Do you remember or know the part number of the seal you installed . No one around my parts stores can tell me . Please let me know if you can ??? Good Video .
@rallycatgarageharvey1135
Жыл бұрын
I will check with my parts supplier and let you know.
@ArtBorquez-ij3kd
5 ай бұрын
You were off to a good start but I didn't see the instuructions. All of a sudden the axle was off and I have no idea how you got it off.
@rallycatgarageharvey1135
5 ай бұрын
Hello .You remove the 4 bolts that hold the retainer plate onto the backing plate .I then used a small slide hammer to pull the axel out .Mine came right out in the video .Sometimes they require a little more force . Hope that helps.
@sharbuck74
5 ай бұрын
What type of hammer did you use to press on the bearing ?
@rallycatgarageharvey1135
4 ай бұрын
Just a 2 pound sledgehammer. It does not take alot .
@cosme2032
2 жыл бұрын
Did you have to apply grease on bearings?
@rallycatgarageharvey1135
2 жыл бұрын
I did put some motor oil on the axle shaft before pressing the bearings on . Helps it slid on better .
@ray6976
6 ай бұрын
What were your symptoms of bad rear bearings?
@rallycatgarageharvey1135
6 ай бұрын
Hello .My car had a humming noise from both sides in the back . I think it would get louder when going around a curve in the road .It was an old used rear differential and probably original bearings from 1968.Still works good and quiet several years later .Drive the car several times a week.
Пікірлер: 20