No problem, Measuring the chain is the best way to determine if its its elongated.
@dumabvuma9171
2 жыл бұрын
How to put timing is Nissan in z24
@jamesmartin5370
2 жыл бұрын
These will not work in the Nissan Z24.
@charliebracker4930
7 жыл бұрын
Mr Jim, how can I contact u to get the information on where to buy the repair kits for my 1997 Nissan Pickup? Please get back to me...thx.
@Mr1jim
7 жыл бұрын
i apologize for the late reply, contact me at jamesmart55@hotmail.com and I will send you some info.
@JesusRAMIREZ-rb5bc
8 жыл бұрын
Where do you buy the shim kit?
@Mr1jim
8 жыл бұрын
Send me an email at jamesmart55@hotmail.com and I will send you some information you can take a look at.
@damian17313
7 жыл бұрын
what the best way to time nissian truck 2.4 engine sept buy sept it a chain
@Mr1jim
7 жыл бұрын
With a warm engine at about 800 rpms Unplug the TPS and set timing to your engine specs. usually 10 degrees BTDC for KA24E Your timing spec should be on a sticker under the hood.
@jogmas12
5 жыл бұрын
Is this the Z24i?
@Mr1jim
5 жыл бұрын
No, its the KA24E
@jogmas12
5 жыл бұрын
Mr1jim so the z24i would have a different tensioner and chain guide and not have the same inherent problem you think?
@Mr1jim
5 жыл бұрын
@@jogmas12 The Z24 has a different chain, tensioner and different slack side guide. Tensioner is at bottom on the Z24 and pushes directely on the chain. Slack side guide is mounted solid with two mounting fasteners. Slack side guide is adjusted to snug the chain manually on the Z24 at time of a new chain install. If the guide is not adjusted manually at time of install the chain will make noise even with a new chain install. Upper fastener hole in this guide is slotted to allow adjustment. If you can access this upper fastener you may be able to loosen and adjust guide into chain if there is still enough room in the slot to make another adjustment. If the head or block have ever been milled this lowers camshaft and in effect makes it necessary to swing the guide farther to make the snug chain adjustment. The Z24 can have chain rattle, can sometimes be fixed by manually adjusting slack side guide to snug the chain.
Пікірлер: 14