Your comment about the un-needed washer made my week! Thank you!
@daveshegedin2576
Жыл бұрын
Good video! In my youthful ignorance and not being aware of the important dot mark on the float chamber cover and its meaning I erroneously put a fibre washer in between the float chamber and float needle housing...chronically over-rich mixture resulted in some serious engine damage on my 1967 Saint. A hard lesson..never forgotten. Cheers. Dave. New Zealand.
@everettballenger7880
Жыл бұрын
Very useful video - thank you very much for taking the time to make it.
@billparr4723
Жыл бұрын
The unneeded washer info is valuable as i bought a new monobloc recently and it actually has a fibre washer between the body and the float valve seat, plus more modern drawings show a washer in situ. I learned the hard way that by incorporating a washer causes the float bowl to flood with fuel, so bottom line old carb models have no washer. Newer ones do feature a washer… Lesson Learned.
@paulhayestiling2214
Жыл бұрын
Thanks very much lad, having problems with a 1963 James cadet, trying to start it is hard, even harder when the engine is hot. Now I have a few things to check. Paul in Ireland 👍🏻😄
@peterjons3954
Жыл бұрын
Very informative. Thank you for taking the time.
@daveco1270
Жыл бұрын
Lots of good info. I put one of those thick insulators on my TR6 thinking that thicker would be better as far as heat transfer, but it made it nearly impossible to get the pancake filter on. So I went back to the slightly thinner version. Crazy how a couple mm's can cause problems. I should have released it was already a tight fit.
@karthikrudrashiva8645
2 жыл бұрын
Really Informative I have one, need to rebuild it
@stuartosborne3013
2 жыл бұрын
Cheers For sharing info
@kelp4262
Жыл бұрын
been cleaning one of these out. should fix the idling on my t100
@tmn32001
2 жыл бұрын
Where did you buy the clear cover to check the float height? I have the same carb.
@kbrickell4732
2 жыл бұрын
use a bottoming tap, or stage 3 tap, or thread cleaner tap
@mikejurcisek3541
2 жыл бұрын
Ben, Can You please refer me to your company you used to get your Monobloc Resleeved?
@johnthomas4249
2 жыл бұрын
Did you use any sealer on the thin paper gasket where it attaches to the head ?
Пікірлер: 14