My bed was warped... that should be number 1 to check to save time.
@Frosty301289
3 жыл бұрын
thank you so much, i was wondering why some of the belts seemed to be way more loose than others, now i know that i can tension them myself
@rainydaytoast1490
4 жыл бұрын
Hi, good tutorials. Can you please do a tutorial on how to adjust the E Steps for the extruder? Thank you!
@GhostGK21
4 жыл бұрын
I would like an tutorial on e step adjustments too.
@helloween2186
4 жыл бұрын
Hi iv'e tried all of it but still got some uneven bed leveling on the predator are there other things to check?
@Gallery90
4 жыл бұрын
Try heating the bed to around 50C and trying the leveling again.
@Gadgetmawombo
4 жыл бұрын
Make sure to do part of the levelling while printing the test print. The book shows you where to do this while printing. It lets you get finer control than while not printing and the bed being hot makes it be subtly different than if cold.
@hardgore5814
4 жыл бұрын
now give me the cura2 profile. not the cura1
@sharkmusic9636
3 жыл бұрын
Now give me a "please"
@petermaerkitz2846
3 жыл бұрын
The big problem of this printer is that you can adjust the z-offset only in 0.4 steps! Closed firmware! I do not understand why Anycubic did this horrible thing!
Пікірлер: 10