Ευχαριστώ πολύ με βοηθήσατε πολύ να λύσω το πρόβλημα μου !!!
@miklosvarga8670
3 ай бұрын
I did the same one, successful one. Thank you
@octaviansorescu7427
7 ай бұрын
Ok! Thank you very much!❤
@PaulAntonescu
8 ай бұрын
did it ever cut flames again w/o the bumper?
@octaviansorescu7427
7 ай бұрын
Hello! If you didn't put that small black plastic protection, didn't it give error 5P3? Was that little piece blocking the piston? Or don't let the piston open all the way?
@michalaron4784
7 ай бұрын
Because of loose little bumper, piston can't fully open gas valve, too much air, lack of gas in combustion chamber cause flame cuts
@istvanfejes7815
7 ай бұрын
I am currently struggling with an Ariston Genus One 5P3 error. I replaced the gas valve, which was clearly full of dirt and the filter was torn. But the 5P3 error is still present with the new gas valve.
@octaviansorescu7427
7 ай бұрын
What do you call a bumper? That little black plastic piece in the piston head? It's like you chose not to wear it!!!! Or did I not understand correctly? I saw that the piston that regulates the pressure had a small plastic piece. In the end I understood that you didn't put it on the assembly anymore.
@michalaron4784
7 ай бұрын
Bumper=little black piece, it is kind of rubber material, it's supposed to avoid clicking noise when valve opening, therefore "bumper", I think due aging rubber get shrinking and do not hold in place-in piston.
@ryszardidkowiak8625
7 ай бұрын
Witam, mam od miesiąca ten sam problem. Pytanie czy po likwidacji "zderzaka" błąd 5P3 powrócił po jakimś czasie?
@michalaron4784
7 ай бұрын
Since removing bumper no flame cuts
@mihaicornea5922
7 ай бұрын
Hello! after all, you still put the Bumper Little black piece, or not?
@michalaron4784
7 ай бұрын
without bumper
@jamespoland3078
8 ай бұрын
Do you know the fix for fault 503 flame sensed with gas valve closed
@kamen0s22
2 ай бұрын
hello James, have you found solution for error 503 Flame with gas valve closed ? Thanks
@matiaspitu
Ай бұрын
What product do you use to clean parts?
@michalaron4784
Ай бұрын
izopropylalcohol- IPA
@octaviansorescu7427
7 ай бұрын
Did you put it back or not? Thank you!
@michalaron4784
7 ай бұрын
I didn't
@giuseppeavellina508
7 ай бұрын
Grazie di vero cuore se per favore mi puoi dire se il paraurti lo devo mettere si oppure no grazie di vero cuore
@luk5827
Ай бұрын
PCB board it's the problem for all Ariston Alteas / Genus One gas boilers .
@gerikuper6473
6 ай бұрын
You silver problem or is still there and you need to fix the pcb part.
Пікірлер: 27