The gearbox output shaft and the final drive UV joint are often "phased" so its important to ensure the keyed portion of the splines are lined up. Otherwise the shaft will be unbalanced and vibrate. Some models are like this others are not, so check first.
@douglasdickson6986
2 жыл бұрын
Can you clarify phased please? Are there markings?
@Feinrizulwur
2 жыл бұрын
Indeed. Markings of original position helps before taking apart.
@1VictorWright
2 жыл бұрын
@@douglasdickson6986 Markings no but it's quite obvious as there is a wider gap between splines which has to be aligned with the shaft.
@remyassier1758
3 жыл бұрын
Y ou ought put the bearings in fridge for a night that is easier to insert great job
@user-fq5wd7wm7y
5 ай бұрын
Крутые динамометрические ключи, а подшипник забивает молотком
@kevantye362
3 жыл бұрын
Put your bushings in a freezer first....makes installation easy...
@mirkoneumann13
7 ай бұрын
Ice spray
@dutchsailor6620
3 жыл бұрын
Small tip, always first remove the filling plug. If any previous owner molested the inner hex of the filling plug, you wont get stranded with an empty final drive that you can't refill. (dont ask me how i found this one out :-( )
@Feinrizulwur
3 жыл бұрын
An other small tip. Do use PTFE tape as sealant. Prevents corrosion steel /aluminum and makes easy to remove next time. Always works and never leaks.
@Feinrizulwur
2 жыл бұрын
If the original bearings are cleaned and re greased just sometimes it helps. Much easier an cheaper. Use a long term water resistant grease.
@godrosydenes4636
Ай бұрын
Hello! Thanks you movie! It is very helpfull! Where can i buy these ball bearings? I have r1100r from 1996. I am living in the EU! Thanks a lot!
@medvedmedvedoff4803
Жыл бұрын
These bearings is a permanent pain of this model, especially if you ride gravels & offroad. I made two polyoxymethylene (POM) bushings to replace bearings & installed it. I rode ~5000 km (include 2000 km of bad roads & gravel) all OK! If it will working well at 20-25k km, it will be very well! 1000mm×40mm POM rod costs approx 1500 RUR (20-25 USD) and some lathe work - cheapest replacement!
@pilgad01
2 жыл бұрын
Very well done video! Should the bearings be torqued in the inverted sequence? RHS first because is is fixed, then the LHS for proper conical bearings compression, and finally the RHS locking nut?
@thurstonhowelliii9501
2 жыл бұрын
Correctamundo!
@jtreg
3 жыл бұрын
Nice watch mate... what model please?
@douglasdickson6986
2 жыл бұрын
When I bought mine I was told to torque to 160nm but my friends say its too much for these new bearings and just take the right one to 80nm and just 'nip' up the inside one. Can someone clarify?
@user-ez9bd9rf3h
2 жыл бұрын
Что то ты неправельно затяжки делаешь . Подшипники не так тянут.
Пікірлер: 22