The Best Calypso tutorial I have ever seen on KZitem!
@stevegyro1
2 жыл бұрын
Yes. Great video sir! GD&T, as in “life - like a bowl of cherrries..”. You never know what you are going to get. You just HOPE that the person specifying GDT on their design document, knows what the heck they are doing!
@nobbyassmann
4 жыл бұрын
Excellent video, thanks! Have been programming CMM's for 30 years, but I'm new to Calypso. Very helpful video for me, to get used to the Calypso way of getting things done.
@megandjasper
8 ай бұрын
How would you handle surface profile called out to AB where B is the bore pattern?
@Zeztuku
8 ай бұрын
Once the Alignment is created from the bore pattern. It may be used as the alignment within the Profile characteristic itself.
@trppurushothaman7024
2 жыл бұрын
Very nice sir, further pl present MSR rack probe seating and each probe calibration including master probe
@alanchang0118
2 жыл бұрын
Thank you for your video, sir. It’s easy to understand. I have a question, is it possible to determine the center axis by radial bore holes such as the B datum holes in this video? Could you give me some advice? Thanks a lot!
@ginotacobell3098
3 жыл бұрын
Sir, can you do a video how to check a Dovetails groove? Thanks a lot.
@ahmadpoerdjo7904
2 жыл бұрын
I want to ask how to open a locked planner file, the surface free form file cannot be opened in cmm calypso axcel, video tutorial, thank you
@rahulguys
2 жыл бұрын
Sir for nominal we have to use coordinate value or polar values
@rahulguys
2 жыл бұрын
Sir we have to use nominal values in bore pattern?
@anilhalli2027
2 жыл бұрын
What is the salry for .....
@WasimAkram-ln3gr
3 жыл бұрын
Excellent videos sir can u shares Calypso notes?
@Zeztuku
3 жыл бұрын
What notes do you mean?
@-EmCEE-
4 жыл бұрын
No sound!!
@Zeztuku
4 жыл бұрын
Sound is there. Check the speakers on your end :-)
Пікірлер: 17