That build is coming out nice. Looking forward to seeing it on the water.
@RogueMTRafter
Ай бұрын
@@fredfields7281 Thanks. Its coming along..
@jaimeorozco9122
Ай бұрын
Beautiful setup I know your pain
@jeanlephunk
11 күн бұрын
Did you weld the console to the floor? Wonder how you did it i want to do a similar project… amazing work brother
@RogueMTRafter
11 күн бұрын
@@jeanlephunk Thanks 😊 The console and rear bench are mounted to the floor with M8 bolts. The bolts are smooth headed and topped with flex tape so they don’t wear on the floor. They have slim lock nuts on the top of the floor, with permatex thread locker. Then I drilled out the mounting holes at the bottom of the console and bench to go over the lock nuts, leaving enough threaded post to add a heavy washer and nylon lock-nut inside the bench and console. They are mounted solid. Same on the seat post. You’d have to blow this up with dynamite to remove them at this point 😂
@jeanlephunk
11 күн бұрын
@@RogueMTRafter thanks man hopefully mine comes out half as good as yours 😂😂
@jeanlephunk
11 күн бұрын
@@RogueMTRafter you should make a company and sell these made, these are going for 20-30k the way your building them
@Bigfishfun333
22 күн бұрын
Wow - incredible boat. Question: at what point do you get an all-welded (or riveted) ALUMINUM boat and not the inflatable? Thanks.
@RogueMTRafter
22 күн бұрын
@@Bigfishfun333 I actually prefer an inflatable boat for my budget. If I had an extra 80k laying around Id probably be running a big crestliner. For the money this boat will safely do everything I need it to. You’re not likely to sink in an inflatable boat either.
@Bigfishfun333
22 күн бұрын
@@RogueMTRafter Less expensive, safter, and lighter (better water and towing fuel economy). Not bad.
Пікірлер: 12