Well done on the video. I'm working through the same process but I hit a snag during reassembly. After installing the new bearings and seals in the hub, I'm struggling to get the axle pressed back through the bearings, as it's a very tight fit. Did you happen to record that reassembly process? Or any advice on how you completed it?
@CayRome
4 жыл бұрын
Great Video! Thank you for taking the time!
@letskillsumtime7520
Жыл бұрын
Nice work. Should of cleaned up the damaged lip for the oil seal
@Hiperf
3 жыл бұрын
I would have debated on giving that race a couple tacks to hold it in place. I would guess its just going to spin. 🤔
@brettfoffel4906
5 жыл бұрын
This was very helpful, but their wasnt even a cage left on mine😂😂
@jimburdick277
5 жыл бұрын
Need 2 replace wheel bearings on my ol gehl hl4500, need input thanks
@TheRamiuss
4 жыл бұрын
hello everyone, i have a problem with my case 1845c, could anyone advise me? When I lift the whole loader arm with a spoon, empty or full, it doesn't matter, it lifts up well, but down it goes very very slowly. It always jumps a little up when starting. The spoon can be opened and closed well. When I turn off the engine the loader arm goes down well. If I go down and at the same time open and close the spoon it goes a little lower it faster. Even if the loader arm does not move, the hydraulics sound as if they are hissing, as if the hydraulics are working. At the same time, the right side of the wheel control does not work properly. Please advise what the problem is. The hydraulic fluid is full. Thanks for the reply
@218philip
5 жыл бұрын
It’s a pain to grease the spindles, so they don’t bother. Pay me now or pay me later.
Пікірлер: 8