I just watched myself do the same rust flinging. Good times in a shitty dream..
@chadsimmons6347
2 жыл бұрын
i would have scrapped the pot & bought a new 1, but your effort to fix the thing was remarkable.
@connormcmahon3724
2 жыл бұрын
That would be logical thinking and makes sense. There was a sentimental value on it more than anything and it didn’t take very long which slightly justifies it. Thanks for watching though!👍🏻
@davidemarchi6366
2 жыл бұрын
you have to preheat the entire pot, not only a spot. Otherwise, this is similar to spot welding, there was a localized expansion. You can do no preaheat at all, with the right stick.
@connormcmahon3724
2 жыл бұрын
Thanks, makes sense and good to know for next time. I also had no way of heating the entire thing and working with it then. 😅
@bareavis
2 жыл бұрын
What size and type rod are you using? Great video!
@connormcmahon3724
2 жыл бұрын
3.2mm CP1010 Cast Iron rods. Glad you enjoyed, thanks for watching!
@paulmeersa7162
7 ай бұрын
JB Weld..?
@connormcmahon3724
7 ай бұрын
Would work too!
@mrdddeeezzzweldor5039
Жыл бұрын
It doesn't take that much effort to prep the entire crack area a few mm either side of the crack, inside and out. Keeps further impurities out of the weld pool - less to burn away and more to fuse.
Пікірлер: 12