Great video, especially taking the time for the close ups to show what's going on.
@brucearney9536
2 жыл бұрын
Take a black sharpie and color the rail , you can really see it happen !
@robertshoemaker6204
Жыл бұрын
I like to pull the rail in first then true up with the pfeifer file jig....sharpie pen is a great idea will try that next time. Shoe in SW Oregon.
@jimenote5924
8 ай бұрын
Excellent video! Be sure to brush away the filings when done. I’ve gotten some nasty metal splinters from this process.
@yveslarose4774
3 ай бұрын
Realy nice video Well explained And close-up shot To help people understand what you are doing. Thanks for it 😊
@pierrelabbe3173
Ай бұрын
Love M.T.L Merci 😮
@elitebowman5386
Жыл бұрын
Just what I was looking for, this video. Thanks for sharing this. I know about doing this procedure, I just haven't had any luck the way I have been trying to do it. I have tried a file and a sander. My brother is a Logger so he does it good but I haven't had any luck. What is the name of the dressing tool ? Thank you
@666dynomax
Ай бұрын
I need that guide.
@gunterbecker8528
7 ай бұрын
A carpenters square pushed against the side of the bar with sandpaper on the short side and Bob is u uncle. Lots cheaper n effective!
@IJustStep
6 ай бұрын
Great idea
@jaydee5091
2 жыл бұрын
What causes the bar to wear? I get deep groves in my bar...I'm running a 76inch wide milling bar... I appreciate your vids man!!
@richardflagg3084
2 жыл бұрын
At the end of the day, it's metal against metal you'll have some wear over time. You'll have to inspect how well the bar oil your using is lubricating the bar and make sure the oiler is turned up to it's max setting. Maybe try a different brand if you're having excessive wear or manually add some while milling. What type of set up do you have?
@jaydee5091
2 жыл бұрын
@@richardflagg3084 much appreciated 🙏 yea ill look into that forsure
@jbbolts
Жыл бұрын
if you throw a chain it can cause burs... lack of proper oiling also
@markkevin2114
11 ай бұрын
Buddy Love it but what's the name of the tool?
@brettholland9165
2 жыл бұрын
Great video!
@DimemanRobbie
6 ай бұрын
I have an old Craftsman that the top/bottom of the bar look decent but the tip, where the guide pins are, one side has a deep groove and the outer edge is higher then the groove. Is it possible to dress the tip on the bar without messing up the guide pins?
@vectorspeedandconditioning97
4 ай бұрын
Should you pull the file instead of pushing when you file the other side so the file doesn’t get worn out?
@richardflagg3084
4 ай бұрын
Fireball Tool has a interesting video on back-dragging the file. I've always been told it would wear out the file too. I was enlightening.
@antoniosolari1013
8 ай бұрын
Thank you
@richardfuerst5286
2 жыл бұрын
ok Richard, looks like I'm going to make a jig for me. 😁
@richardflagg3084
2 жыл бұрын
The best tools are made in the shop. I like how you think.
Пікірлер: 23