I appreciate your posting this video. Really helpful.
@Harris4465
4 жыл бұрын
This was great. I am a bit uneasy doing stuff like this for fear of making it worse than when I started. This is very helpful.
@customcraft123
12 жыл бұрын
your video really helped me, you answered all of my questions. thanks
@Lewisusa11
3 ай бұрын
I was not aware I was supposed to add a rod between the two gauges, I just always put one at each end. Just found out I need to replace the motor in my grizzly G1017, which is 30 years old. Cutter spins but not the feed chain side. :( Ugh!) great video, thanks!!!
@nigealandrews2337
2 жыл бұрын
You was simple understanding an quick good job
@jrx2662
6 жыл бұрын
great video you see the whole thing up close!
@faw3511
6 жыл бұрын
This gauge sets the knives parallel with the cuttinghead, not parallel with the planer table. Sometimes it's necessary to set the knives higher on one end with a dial indicator jig to square them with the table.
@raymondbunkofske4702
3 жыл бұрын
It depends on the planer. My Jet has a separate adjustment to set the cutter head parallel with the bed.
@m4chschnell
11 жыл бұрын
do you find that when tightening the bolts the angle of the blade to head causes the balde to drop a bit . If you do I have started using magnets to hold the blade up real;ly tight against jig and tighten all bolts centre first and outer edge last . When you tighten them up check wth a feeler guage to see if they have moved
@tomtpace87
6 жыл бұрын
What type of planner is this?
@G3RR1TJVR
8 жыл бұрын
I have the planer, but do not have the tool to determine the height. I bought a tool that can be adjusted to the correct height, but I do not know what height to set it to. Could you perhaps advise what the correct height is?
@TyCetto
8 жыл бұрын
Normally, if the knife is ground to the normal cutting angle, you should see less than a millimetre of the flat side of the knife body above the cutter head surface. Never place the knife so that the ground bevel is 'drowning' under the edge of the groove where the knife is sitting.
@SinCityWoodworkers
6 жыл бұрын
This is a Bridgewood 24" planer
@flagman40
Жыл бұрын
Where can I get that tool?
@kimonecampble1166
4 жыл бұрын
Where can I get the blade to perches
@gurmailsingh8900
4 жыл бұрын
Sir how price to 10" thikneser
@wmcrash
11 жыл бұрын
what model planer is this?
@SinCityWoodworkers
4 жыл бұрын
This is a Bridgewood 24" model, bought back in the 90's. Great tool!
@stairman2
12 жыл бұрын
I have the same planer, and setting tool. But Where did yu get the springs? Mine didnt come with them? Seems like a easy way to set them.
@Yawles
7 жыл бұрын
stairman2 I went to a local farm & fleet store, or Menard's has springs as well. make sure you know what size. I got springs that were just barely under 1/2" x 1" for about a buck each.
Пікірлер: 21