This video is how to change both the drive pulley and the belt on the MINI LATHE. (MUCH) More information below!
Please like and subscribe if this was helpful!
Stuff from this video:
Pulley: amzn.to/2qyiv4t (I ordered the 15 and 17 tooth pulleys)
Belt: amzn.to/2pEGHho
Belt Size: 5mm pitch, 85 tooth, 9mm wide, 425mm long timing belt
Lathe: amzn.to/2nVBrEc
Stuff on the lathe:
Quick Change Tool Holder: amzn.to/2oZtFee
Tailstock Drill Chuck: amzn.to/2pmE0jX
Lathe tools:
Boring Bar: amzn.to/2pmy0b1
Carbide Tools: amzn.to/2oRZWax
Parting Tool: amzn.to/2nVCeW1
Center Bits: amzn.to/2oRRV5n
Drill Bits: amzn.to/2oz9W76
Other stuff:
Cutting oil: amzn.to/2ofkPaY
Mini Lathe troubleshooting guide: littlemachinesh...
Controller board wiring configuration: imgur.com/KIEzu92
The real version of the motor controller: amzn.to/2orw43F
Datasheet for the KBIC-120: www.galco.com/...
Super nice guy who repairs the controller boards: olduhfguy.com/
Music:
/ jeff-kaale
/ maxzwell
Негізгі бет Changing the belt and upgrading the drive pulley on the mini lathe
Пікірлер: 122