Thank you Incogni for sponsoring this video! Take your personal data back with Incogni! Use code INHERITANCE at the link below and get 60% off an annual plan: incogni.com/INHERITANCE
The lathe has been glaring at me for 4 months, it’s time to put it to work. And by "it", I mean me.Which, as you might expect, never goes quickly. And while I can’t promise a super satisfying reveal, can I tempt you with a negative side project total? Who would have believed it?!
#inheritancemachining #machineshop #hobbymachinist
Patreon - / inheritancemachining
Drawings Store - inheritancemachining.com/?pro...
Merch - inheritance-machining.mysprea...
Instagram - / inheritancemachining
Amazon Store (affiliate) - www.amazon.com/shop/inheritan...
Thank you again to the Micrometer level Patreon members listed at the end of the video!
TIMESTAMPS
0:00 Intro
0:55 Two Is Better Than Zero
2:04 Simple is... Boring
3:37 I Overthunkit
6:18 A Little Over Dressed
8:22 sniff sniff
10:08 Spring Break, Baby!
11:33 What's that tickin' Noise?
12:52 Gettin' Smok'd
14:56 Hyperbolic, Dontchathink?
16:58 Rookie Mistake
18:27 Indecent EXPOsure
19:45 Hot Date
FAQ
Drafting Equipment (affiliate links): amzn.to/3P0HvMe
A/V Equipment (affiliate links): amzn.to/3Pi45jB
Editing: Final Cut Pro X
Intro Song: Way Back Way Back When (Instrumental Version) - Gamma Skies
www.epidemicsound.com/track/S...\
This video was sponsored by Incogni.
• Chasing my own Tail(st...
© 2024 Inheritance Machining, LLC. All Rights Reserved.
Негізгі бет Ғылым және технология Chasing my own Tail(stock)
Пікірлер: 652