Good visual video. I like videos like this where issues are shown, then solutions enacted and if necessary adjusted again. A confidence video for anyone wishing to tackle it themselves.
@maxautouk
Жыл бұрын
Thanks for the kind words 😄
@colinsmith7233
5 ай бұрын
Great video. Just what I needed to see. My C3 is about as rusted up as yours. Finished the job today on my car, I think it would not have gone so well if I had not see your video. Many thanks for posting it..
@maxautouk
3 ай бұрын
Glad it helped !
@iqb62
8 ай бұрын
Thank you for this video. Good work.
@maxautouk
7 ай бұрын
Thanks for the comment!!
@Juris.Ivanovs.2079
2 ай бұрын
Tusen takk.
@maxautouk
2 ай бұрын
Np
@aaronmachon9127
Жыл бұрын
Very informative. Always good to have informative videos like this that show you what to do also..😊
@maxautouk
Жыл бұрын
Thanks very much for the comment glad it helped!!
@aaronmachon9127
Жыл бұрын
Very welcome mate. Same car so just glad you never missed anything
@MarekMalevic
4 ай бұрын
Thank you for a very helpful video. IMO it makes no sense to try normal Torx in this case. I have damaged one and then bought torx for impact wrench. And that one worked very well.
@maxautouk
3 ай бұрын
They are crazy tight too!
@xerejuneseve6333
9 ай бұрын
Is it worth to buy this c3 for 500$ with bad front bearings?.The model from 2002 and diesel 1,4V -270 000km.
@maxautouk
9 ай бұрын
The diesel 1.4 is a horrific engine but if everything is healthy with the engine then just wheel bearings would be fine for that price
@wodzimierzknapik6741
7 ай бұрын
Great movie. But... You should clean rust on the nuckle arm firts...
@maxautouk
7 ай бұрын
The knuckle arm?
@wodzimierzknapik6741
7 ай бұрын
@@maxautouk Steering Knuckle
@maxautouk
7 ай бұрын
@wodzimierzknapik6741 what would cleaning off the rust achieve?
@wodzimierzknapik6741
7 ай бұрын
@@maxautouk Bearings don't like dirt. We see a lot of dirt and rust during assembly.
@maxautouk
7 ай бұрын
@wodzimierzknapik6741 the inside bore was very clean and both sides of the bearing have seals to keep debris out - where i live rust like this is normal and this bearing has been totally fine! ☺️ also dont forget the flange and driveshaft are not fittwd water tight to the bearing so they are open to the elements constantly
@mazdaman1286
11 ай бұрын
with torx always buy 2 . citroen 100 nm plus rust honda 55 nm some manufacturers go overboad on torq specs.
@maxautouk
10 ай бұрын
I think the torque isn’t too bad but yeah you’re right about the rust it’s a nightmare sometimes!
Пікірлер: 27