Thank you for making this video which helped me cure my troublesome Husqvarna hover mower which would only run on full choke. Having watched your tutorial it's now running like a sewing machine! Best wishes from Ireland ☘
@KillRbee0218
2 жыл бұрын
Dude, You are freaking awesome! I got my lawnmower running by doing what you said! Everybody listen to this guy!
@TheCdnAdventurer
8 жыл бұрын
This was a great video. Helped me a lot with figuring out how to take apart my leaky carb. Looks pretty well identical to mine. and I just now realized that my float pin came off the float so now I'll be taking it apart again and connecting the pin again. thanks a bunch for posting this. Great work!
@rodmagee7895
4 жыл бұрын
Thanks, installing the float was what I wanted to see and it was out of frame BUT you forgot to hook the float needle and that is what I wanted to know about YAY for forgetfulness. Great vid. Thanks again.
@dougsawyer4050
9 жыл бұрын
Thank you SuthrnRepair! My son and I followed your steps and our 12hp craftsman runs like a champ now.
@pflueger41
5 жыл бұрын
Thanks...getting ready to clean my carb and found this to be very helpful.
@joesaccomanno4791
7 жыл бұрын
Great video! You thought me a lot. Going to see if I can get my snowblower going again with your video. Thank you
@jamesjarrell7883
10 жыл бұрын
Thanks a bunch took mine apart cleaned it and now it runs perfect !!
@wilsonwilson3445
9 жыл бұрын
Awesome! No one ever shows how to orient the bowl when you put it back together. Thank you!
@wickedloudone
8 жыл бұрын
Just wanted to say thanks, my snow blower wouldn't stay running for more than 30 seconds before stalling fully choked,. Pulled the carb off, cleaned it, bought a new bowl seal and intake gasket and it started up 1st pull. Had to start it a couple more times to make sure it was going to start again but, it didn't stall after that and ran a good 10 mins without a pop or sputter... ~ Master procrastinator
@lucacaleffi9396
4 жыл бұрын
Thanks. Watching this video I have decided that it's better to pay someone to clean my carburator.
@TP-es1pf
5 жыл бұрын
Thanks for the vid. The correct height for the float is to lay a 11/32 drill bit under the front and bend that tab to just touch it. Also the straight edge of the wire clip must point towards the air cleaner side, not the engine side or it will bind.
@MrStatic101
10 жыл бұрын
Thanks man. This helped a lot!!!
@surestang7932
7 жыл бұрын
Thanks. Your video was helpful. 👍👍👍
@JustMe-mg6vw
3 жыл бұрын
I love these videos!
@ottodierksheide9004
4 жыл бұрын
Now I can get my mini bike running thanks so much man
@magicone9327
3 жыл бұрын
Mine would not quit surging until I ran a small flexable wire ( copper ) thru the holes at the throttle butterfly. Then cut the tip of the carb spray to a 45° so it would seal against those holes when entering the Venturi. After that blew air into the needle hole and that did the job. Now it runs like new.
@deankdx
Жыл бұрын
thanks for this video, bought a mower which was flooding due to sticky float, got it free'd up without removing the carb completely and mowed the lawn, but next day fuel is gone from the tank, so thinking float might be stuck again or float level too low or not clipped into the seat as you demonstrated. (could also be a leaky hose. no fuel evidence unfortunately)
@koolcat78956
5 жыл бұрын
Which one was the video for tuning it? Thanks!
@tyronebutler7302
10 жыл бұрын
very helpful thank you
@davidschwartz5127
7 жыл бұрын
I would like to point out for your health's sake please wear latex gloves when working with any chemicals they do get absorbed thru your skin and will eventually affect your liver. Also great video, it helped me a bunch.
@johnoktavec
6 жыл бұрын
i agree david.good vid,wear gloves.
@rikkitamy2562
10 жыл бұрын
Hey i've got a mower vantage 35 tecumseh new garda, castelgarden, 2.6 kw 30kg how much does it cost one these days?
@nighthawkj30A4
3 жыл бұрын
I rebuilt my Tecumseh Series 11 carburetor almost 2 years ago with Original Tecumseh Service Parts. That engine has been running so well. Makes me wonder why they stop making Engines.
@mikecucc9656
7 жыл бұрын
Could you tell me Why does fuel come out of the air filter from the carburettor? Thanks
@chetg2924
8 ай бұрын
Ive taken mine apart and am used to the old mini bike carbs. I do however have a small small small spring associatedwith the float inside which I have no idea why I need to go the trouble of figuring how it goes. How important is the little float/needle spring?
@marchondaracing
10 жыл бұрын
Your float is way too low, you need to level it up ( little bit more that horizontal). And by the way, ¾ to 1 on the side and 1½ on the bottom on the screws.
@jorgecastilla1241
5 жыл бұрын
Nice job
@glengrossnickle4985
Жыл бұрын
Do you know where I might be able to get a after market carb. For a snowblower about 30 years old. Anything will help thanks
@followthesun2115
6 жыл бұрын
Carb cleaner for sensitive skin. lol Great video!
@lookeywho1287
9 жыл бұрын
Good vudeo of your hands
@charritolopez8223
5 жыл бұрын
Does anyone know where the linkage goes on the one that has about six holes I took mine of for cleaning and now I can't remember where it goes I have been looking for videos here and no one shows how to put it back only cleaning them any info would be greatly appreciated thanks
@p47thunderbolt68
6 жыл бұрын
Thanks, wish I'd of watched this before I messed with mine
@edwatt4506
8 жыл бұрын
Helpful , however if you used your pick as a pointer more and kept the subject in frame it would be better. Thank you.
@69reBob
8 жыл бұрын
(Safety Glasses ) WorkWhat Rebuild kit will you order #
@smartchip
4 жыл бұрын
I have 3 positions on top of mine, likely the choke, what are the positions, which one is choke, no choke and the third, help, thanks,
@wcjcnc
9 жыл бұрын
Can you take the emulsion tube out of that carb? I have one and I can't get the emulsion tube out.
@stevesmith6058
6 ай бұрын
The plastic ones you can remove but you can’t take the ones out that are brass
@stevericci3308
10 жыл бұрын
If fuel comes out of the red straw from the intake of the carb is that the float adjustment
@suthrnrepair
10 жыл бұрын
If fuel is coming out it is 1 of 3 things float adjustment is way off ..or the shut off needle is not sealing and stopping the fuel from filling the bowl .. or the float could be stuck
@stevericci3308
10 жыл бұрын
suthrnrepair thanks for that, I figured it out after watching your video. Float was way off on the adjustment. Appreciate the help .
@estrelladelnorte1308
11 жыл бұрын
nice video! i cant find the tunning video. :(
@leolin1634
10 жыл бұрын
I have a defect Tecumseh Lawn mower (model: 11A435R5150601620-A). after I cleaned out the carburetor, I started, but the gas running out so much from carburetor to air cleaner.Why?Please help me to fix this problem. Thanks. Leo
@alext9067
9 жыл бұрын
Float valve in the carburetor bowl is stuck open. Gas tank is higher than carb so you got that gravity thing. You can take off the bowl and raise the float to see if it's cutting off the fuel flow. I think you'll be fine.
@bakkenboy
11 жыл бұрын
you got it apart so why not re-kit it
@JOEZEP54
10 жыл бұрын
I just came across this video so this may be a little too late. If you look at the float where the cutoff needle is connected to it there is a tab. Bending that tab adjust the float height. Check the specs for the height.
@jimmachen5095
7 жыл бұрын
man hurry up hope you dont get paid by the hour
@samuelcantley5500
5 жыл бұрын
What are we to see
@petem6354
4 жыл бұрын
A pity about the overall very poor lighting on the carb. Otherwise helpful.
@devless2902
5 ай бұрын
guys he stopped making videos what happen😭😭
@Roller76
6 жыл бұрын
I don't want to bash you and your video but, yes but, if you do another video remember to when commentating speak clearly. I got distracted by mumbling and heavy breathing. It sounded like you just ran and couldn't catch your breath. I'm not making fun. If its a health issue bud you need to get looked at. Other than that it was good.
@lulutileguy
Жыл бұрын
i have to wear gloves hate gas will not have on me cow shit ok no gasoline
@hopbrah
6 жыл бұрын
The worst carbs on the market, I can't stand Tecumseh!
Пікірлер: 56