Sehr schon. Preheating the charge is nicely designed in.
@Cjx0r
2 ай бұрын
damn that was bad ass
@zyphryx9
7 ай бұрын
I wonder how often you have to clean all that gear
@SoundShunter72
7 ай бұрын
No point in cleaning anything in an environment like that. It'll all be grey in a few months.
@ph11p3540
4 ай бұрын
I don't think cleaning is needed. They just replace worn refractory tiles and other wear parts. These furnaces are meant to run non stop for months 24/7 and they actually need less maintenance the less time they are allowed to cool down.
@zyphryx9
4 ай бұрын
@@ph11p3540 That makes sense. Always wondered if those plants stopped and started. Seems like it would take a considerable amount of energy to spool back up.
@alessandrodamato5059
13 күн бұрын
This type of system is designed exactly to be turned on and off repeatedly It's not a blast furnace Here every time you make a casting you have to heat the scrap metal However, most gears are protected from dirt or so large that they are not affected
Пікірлер: 8