Looking Good Rogge. Some one I know mentioned getting a Tormach and I looked up the channel and bam..there you are.
@billgreathouse1913
5 жыл бұрын
Probably a bit late to the party but I have a request for development. How about adding tabs for point to point milling? Similar to how the prototrak control has. It is often that I wish that I could mill an irregular profile without the need to modle something. Have a toggle in the upper right, like with drill vs tap, for profile vs pocket. Each segment or radius would have a end or continue prompt. This would link each move. Until end was selected. Then move to retract position.
@beatboxx713
4 жыл бұрын
I agree 100%, sometimes I just want to clean up a basic profile... It would be nice to have a point to point tab where maybe even u could fill inn a table with x and y positions...
@cogentdynamics
Жыл бұрын
I love my new Tormach 440 mill. Your videos are very helpful, thank you. I have a question: using the conversational profile tab, how would I radius the corners on just one side of a part? I guess the same question might apply if we were doing a pocket but wanted larger corner radius on two corners but not 4? Is this possible? I appreciate your time and work!
@mickeymouse-lu2yk
Жыл бұрын
Hoping a refresh will be made that talks to the material selection for feeds and speeds recommendation capability, this is a totally awesome capability if i can get it to work - should be super easy - unfortunately for me i can’t change the material - filed is not letting me.
@toddsutton5672
5 жыл бұрын
So your limited to sqaure or round on profiles?
@BlueSwallowAircraft
8 жыл бұрын
Thanks for the video. Its very helpful as I am just starting to try and use the Conversational on my 1100.
@normcook9335
Жыл бұрын
Looking for info on the DXF tab (In version 24R / 2.8.4
@kyleflynn4384
8 жыл бұрын
can u thread mill a Taperd pipe thread in conversational in path pilot?
@tormachinc
8 жыл бұрын
Yes, you can do a tapered thread operation in conversational. Rogge describes it at this section of the video: kzitem.info/news/bejne/yJptr66FgKZ3fo4
@niemdan
3 жыл бұрын
Save some women foe the rest of us man!
@kyleflynn4384
8 жыл бұрын
I watched this section but he did not say anything about doing a taperd pipe thread where the thread shrinks in diameter as it goes deeper down the hole.
@tormachinc
7 жыл бұрын
Tapered pipe threading is currently available only on the lathe version of PathPilot, but not yet not available on PathPilot for the mill. It is on the list of future additions, but we can't promise exactly when it will be added.
Пікірлер: 13