God bless you. I’m not sure how I did but I could NOT connect my hose back but thanks to your video I realized I had left that one piece in it. Way to go!
@adglen41112
2 жыл бұрын
Thank God! You just saved me from losing money and my mind over a piece of plastic that I had switched and forgot about. Thanks so much!
@jacquelinewilliams632
5 жыл бұрын
Thank you for your help, I was looking for about half an hour for the answer to my problem on various CPAP sites then got on to yours and you solved my problem in the first 30 seconds of your video so once again thank you.☺️
@amberkervahn5133
4 жыл бұрын
Thank you for this!!
@JessicaLaurenVine
3 жыл бұрын
THANK YOU!!
@akshaypanchal007
6 ай бұрын
Does anyone else feel air at the joint where the hose is connected to the mask? Is that normal or does that indicate loose fitting?
@carolineparent3781
Жыл бұрын
Hi, is there a flexi tube that would fit the Restmed Air Fit F20 mask? I am looking for a flexi tube that would go from the mask to the grey tube. Thanks!
@louisesharp9329
2 жыл бұрын
Connection inn the tube to machine
@claykeeton1331
3 жыл бұрын
thanks. was having this exact issue. new mask now fits fine
@Jan99C
6 жыл бұрын
I was told by your phone help folks that in order to make my new nasal pillow connect, I had to remove the snap-n-clip tube and just push the hose into the remaining tube. With help, I did this, but now I can't pull them apart. Certainly, I can't separate them at night when I have to head to the bathroom. My strong neighbor can separate them, but not me. Can i put a thin coat of vaseline, or some other lubricant on it?
@tannergarcia5653
Жыл бұрын
Hello. I need the flexi adapter you show in the video. I cannot find it on your website
@greatspirit
Жыл бұрын
What can be done when the Climateline hose connector becomes loose and no longer snaps to the hose of the CPAP mask?
@cpapcom
Жыл бұрын
Hello! Thank you for your question. In order to better serve you and your situation, we ask that you call our expert customer care team so that we can walk you through a personalized solution. Our number is 1.800.356.5221 - we look forward to assisting you!
@UFC16
6 жыл бұрын
my mask hose is stuck in the main hose
@lazmotron
3 жыл бұрын
Which REMStar hose will fit the Dreamweaver full mask.?The Dreamweaver masks connecter is much smaller than the hose that comes with the remstar plus. Thanks
@Nucloid
4 жыл бұрын
I currently use a quattro fx full face mask. The hose slides off the mask during the night. My thought was to use one of those metal hose clamps to tighten down the end. Seems a bit excessive. Is there a better alternative to tighten the hose end to mask?
@pamelafeltner4015
4 жыл бұрын
Should I feel air around thehead connection of the mask in which I am
@lorrainecole5795
2 жыл бұрын
How do I change tubing?
@meganlove4983
4 жыл бұрын
Should i feel air from the hose? around the connection to the nasal mask .
@lorawalker8314
3 жыл бұрын
What adapter do I use on my resmed air sense 10 machine and a dream wear mask
@MG-lm9nw
Жыл бұрын
did you ever get an answer? I am having the same issue. The mask becomes unattached at the elbow from the hose every night when I move around
Пікірлер: 24