Excellent video, clear illustration of the circuit concepts. Thank you, keep up the great work!
@PHYTION1
6 ай бұрын
Glad you liked it!
@greenaum
6 ай бұрын
In your first breadboard circuit, around 3:20, you haven't connected the two circuits' grounds together. So the circuit shouldn't work. I can only assume it does because the CMOS receiver is so high-impedance it can take the data capacitively coupled, effectively. I think I'm right in assuming the chips don't generate RF, only a sequence of bits to be put onto a carrier wave by other circuitry, that might be infra-red or radio for example. So if you're skipping a transceiver, using only these data encoder / decoder chips, they should be sharing a ground wire, for the signal wire to induce any voltage in the receiver. It's odd that it works at all, and if someone used it as an example, it may well not work.
@matthewsheeran
7 ай бұрын
Surpizingly simple: all that is required is PWM/PCM from/to ADCs/DACs for potentiometer joysticks and higher power TX/RX for longer range with better antennas. A small ATTINY MPU instead would give you N chamnels of ADCs/DACs and/or PWM/PCM in code plus output power transistors plus capacitors in the PWM case..
@testports3216
7 ай бұрын
Great job🔥
@PHYTION1
7 ай бұрын
Thank you very much
@asifmahmud5437
4 күн бұрын
bro can you please provide the motor driver diagram....please🙏🙏🙏🙏🙏
@eltonnascimentopereira558
6 ай бұрын
Reparei q na maioria das pessoas q faz esse projeto usar sempre essas bateria de 9v saberia dizer se pode usar bateria 18650
@PHYTION1
6 ай бұрын
Aqui usei baterias de 9V porque a quantidade muito pequena de corrente consumida pelo transmissor e as baterias de 9V são fáceis de encontrar.
Every time I open the files it says Files type not supported.
@PHYTION1
7 ай бұрын
What file type is not supported? 3D models or PCBs?
@wewe365
7 ай бұрын
Gerber files. I am brand new to this. I’m sure I’m missing something.
@wewe365
7 ай бұрын
Can’t figure out how to send the file to the pcb board maker.
@PHYTION1
7 ай бұрын
there are no errors in download files. try again : drive.google.com/file/d/1tiW_VFvXFbXdXWgTn9Czyb20UWk07fHM/view?usp=sharing (When you click the link, you will redirect to another page. There is a Download icon at top right corner on that page. Click that to download files. Then unzip it. you will be able to find receiver and transmitter PCBs)
@PHYTION1
7 ай бұрын
Can’t figure out how to send the file to the pcb board maker. : First you download the zip file through the given link. then unzip it. You will be able to find two zip files. One for Transmitter PCB and another for receiver PCB. upload these two zip files separately to the PCB maker website.
Пікірлер: 24