It’s been around five months but I finally have a new instalment in my project. Life really got in the way for a while, but now I’m back working on the car properly again. In this video, I work through the planning and fabrication for installing the correct size bushings for the new harness eyelets. This is a major step in getting the car to spec so it can be logbooked with Motorsport Australia.
Welding in hard to reach positions inside a car is not fun.
0:00 Introduction
0:43 What needs doing
1:26 Brains trust planning and delays
Matty P’s channel: / @mattyp4230
Andrew’s Race Cars: www.andrewsracecars.com.au/
4:26 The harness plan
7/16 UNF weld in fitting: www.mcgillmotorsport.com/7/16...
5:04 Cutting bores for the harness bushings
6:32 Fabricating the new chassis piece
www.vevor.com.au/tube-pipe-no...
8:24 The fun of welding inside a race car
11:11 Painting and test harness fitment
12:06 Conclusion
Негізгі бет Cutting and welding the chassis to fit the new harness - finally!
Пікірлер: 76