In this tutorial, I will teach u how to upload the firmware to the Arduino board and the important software needed for this project step by step.
LINKS
All in one- drive.google.com/drive/folder...
Arduino driver - www.arduino.cc/en/software
XLoder - drive.google.com/file/d/1-Bzv...
Hex file-drive.google.com/file/d/1-1Wh...
Wheelconfig- drive.google.com/file/d/1yqYq...
(if this did not work try this- This is the original link- this does not work to me but some regions might be able to open this site - www.aiwave.fr/wc_updates/1033/...)
I recommend you try to use my link it's easy.
Circuit diagram- drive.google.com/file/d/1--3Z...
All the credit goes to @mypc-id @AgaYuditraStudio @ebolzzable
when you are opening wheel config make sure you are opening "wheel config Dev " there are 2 applications inside it, u may not see them in there but you can search in the search bar( type wheelconfig ) and get it! If you get an error message while installing Wheelcinfig software I suggest you change the installing location to another drive and install it.
Item list
12v dc gear motor- www.aliexpress.com/item/40005...
Timing pully- www.aliexpress.com/item/32781...
Arduino Leonardo- www.aliexpress.com/item/40010...
Motor Drive(BTS7960)r- www.aliexpress.com/item/40000...
Encoder- www.aliexpress.com/item/32850...
There are many encoders if your encoder has 5 wires it means the other wire is for the Z, one for the 5v(VCC), the other for the GRD, other 3 are A, B, and Z. since I have used 4 wired encoder I have to use a toggle switch for the Z.
If u have any questions feel free to ask in the chat, I will do my best to fix your problem.
thank you and help me to grow my KZitem channel.❤
Негізгі бет Ғылым және технология | DIY | FFB steering wheel part 2 | Upload the Firmware |Sim racing
Пікірлер: 109