Thanks that P12 and P15 saved me. And oh of course the jumper. Cheers.
@tonismalkov
10 ай бұрын
thank you!
@rickhebbard6272
11 ай бұрын
When you spin up that motor, remember, that key on the motor shaft is waiting to come out and stick into your body. Keep your face away.
@buddywarren3913
8 ай бұрын
I'm trying to figure out how to make the screen not say stop but always show where the POT frequency is set at. Is there a way to accomplish that? Its important for our machinist to know where its set even when its not running.
Жыл бұрын
Hello. in the minute 4 you are explaining the factory reset but after see the P-Def setting what i need to do ?
@Aravindprivacy
2 жыл бұрын
I have one doubt
@jeremiahosagie2287
2 жыл бұрын
Pls help me figure out whats to do, after setting my vfd the motor didn't spin, its a 2hp single phase motor.
@iozsaandrei662
Жыл бұрын
How can I connect this kind of inverter to PC and another questions is how can I test de modbus port if I don't have a PLC.
@jhee0113
2 жыл бұрын
Can I ask why you didn't wire ground from the mains to the vfd? I see the ground wire from motor has been wired.
@IGSElectronics
2 жыл бұрын
I did not do it due to short time use, but you should always use it. Yes my motor is grounded on different point.
@hb5623
3 жыл бұрын
Are these drives made by Invertek? The look the same in settings and case.
@IGSElectronics
3 жыл бұрын
No, there is independent manufacturers that make drives for other companies to save money. Not sure who is making things for who, but yes they are wary much the same.
@ajayjaiswal4488
2 жыл бұрын
Drive fan is not running when will run sir
@delmoncastrorodrigues1931
2 жыл бұрын
Bom dia tô com um mais quando ligo aparece H 0.0 o que pode está acontecendo ?
@backwoodsengineer
3 жыл бұрын
Is there a way to prevent the drive from reversing when the start button is pressed while the drive is running? But still allow reversing from a local toggle switch?
@backwoodsengineer
3 жыл бұрын
I figured it out. I set P-12 = 1, set P-15 =7, then have my switch change the high input from terminal 2 to terminal 3.
Пікірлер: 19