This video shows my starting system for model internal combustion engines. The starter is powered by a 3/8" variable speed electric drill. The drill is bolted to a sliding carriage which allows me to tighten or loosen the drive belt, by means of a 1/2" threaded rod which has a knurled wheel attached to the end you don't see. The secret to this is the over-running clutch which fits internally in the top gear-belt pulley. It allows torque from the electric drill to start the engine, but it does not transfer torque from the engine to the drill. This means that after the engine starts, I can remove my hand from the start button, the drill stops, but the engine can keep on running with no load. I am very happy with this system.---Brian
- Күн бұрын
ENGINE STARTER WITH 0 875 HORIZONTAL ENGINE 001
- Рет қаралды 318
Пікірлер: 2