Hello when you converted to dampers.. I seen you left the little pump assembly on the top of the dampers what did you do to not need it anymore.. I see your not using it anymore.. I have an r3000 and I just ordered the dampers from Niko
@ivanamartinez620
Жыл бұрын
Hi, I have an Epson R3000, I can't get it to print any color. I already took the air out of the hose but I think the dumpers are with air and the ink cannot get there, could you give me some idea to solve it? thank you very much
@allenmayberry3009
Жыл бұрын
Hello how are you I have a p800 can I use this system and if so what about the air that goes into cartridges will that be needed or do you cap that off
@laszlofeiszes5671
Жыл бұрын
Hi , i have a problem with my epson p800 , i dont have inkflow in 1 line i tried to clean all the ink lines dampers everything with hot water but i dont have inkflow i see in lines the white ink try to going to damper but in half way stopping, this is damper issue? if yes i need to change the whole damper switch or is enough the damper behind of damper switch? thank you
@deucedawg01
Жыл бұрын
So total noob here to DTF and Epsons in general. Is there still a debate about using Windex? Or is it just the folks selling other stuff telling you not to use Windex? What is your take on it, have you used other solutions, and do you also use it to cap? Just found your channel, so lots to learn. Thanks.
@IronDesigns813
Жыл бұрын
I've been using Windex in my printers since sublimation lol still use Windex on all my printers it breaks down ink fast which is needed other wise your print head will burn with out ink flow as well as your pump from capping, the goal is to break down ink, pay attention to those who blow their head they are using cleaner, lol i dont wet cap i clean capping station nightly.
@IronDesigns813
Жыл бұрын
join my group facebook.com/groups/craftingwithirondesigns813
@albertocme5777
8 ай бұрын
hello maam how did you remove and bypass the ink selector assembly?
@IronDesigns813
7 ай бұрын
hi i have a video showing how to lmk if you have any questions
@fabioteixeira709
5 ай бұрын
@@IronDesigns813can you send the link for that video? And what cis sistem to use ?
@allenmayberry3009
10 ай бұрын
Do you no the ink order with cadlink using the Nikko ciss
@IronDesigns813
7 ай бұрын
im so sorry i dont use cadlink let me research to see if i can find some answers for you brb
@dripcloud3424
Жыл бұрын
How do you convert an r3000 to use dampers? I don’t see chipless firmware for r3000 anywhere.
Пікірлер: 14