FD3/64 turbine blade shaping / grinding You must untwist the blades by about 10 degrees or it will not run cool and combustor cannot function correctly with too little case pressure.
I'm always wait for your next tutrial video. so thank you so much.
@Umarzaman8400
4 жыл бұрын
Thanks for the video was really helpful. Very nice job done on turbine
@jacobokpara7618
4 жыл бұрын
Hi do you have a video of this process sir? . Am in the process of reading about this part. Great video sir. Thank you
@holmansolis
11 ай бұрын
Excellent video... what gauge of stainless steel sheet did you use? Thank you
@reedy93
11 ай бұрын
most common is 0.50mm thick 304 stainless you can also use 316 stainless shim 0.40mm don't go any thinner unless you use something more heat resistance .
@marciobrito4579
4 жыл бұрын
Very cool!
@YOUTUBE.COM.EZEQUIELRF32CNC
4 жыл бұрын
This material is stainless steel?
@reedy93
4 жыл бұрын
yeah 316 or 310 anything more heat resistant can't be welded easy so stick with stainless i also make the boss out of stainless I used a 316 A2 stainless bolt as material.
@YOUTUBE.COM.EZEQUIELRF32CNC
4 жыл бұрын
@@reedy93 Ok I got it, thanks a lot, friend.
@Umarzaman8400
4 жыл бұрын
Reedy93 hi I upload video check this .Now is start new problem I don't understand why is that behaving engine.
Пікірлер: 10