I would think on a machine of that size you would just swap the bucket pins and not bother with a quick connect. It would probably take about the same amount of time and not loose force and add weight.
@torkelsenhus
3 ай бұрын
It takes about 5-7 min to change pins without quick-connect, which is fine. but the pins are really greasy and I’ve extended the thumb to match with the quick connect. I also like that the boom has more reach.
@03treefitty
3 ай бұрын
Move the upper thumb mount higher. Bring dipper in as far as it goes and weld tabs higher. Keep in mind to keep a bit of angle in tooth claw if it is straight it can go both directions randomly every time you use it.
@dakotak8437
3 ай бұрын
That engine sounding like some bad knocking going on
@torkelsenhus
3 ай бұрын
@@dakotak8437 it’s one cylinder
@dakotak8437
3 ай бұрын
@@torkelsenhus I got ya lol
@bmexcavation957
3 ай бұрын
Good video your like me that’s your side kick can’t have it broke
@torkelsenhus
3 ай бұрын
We fix it:)
@inseiin
3 ай бұрын
You should really really really get a plasma cutter :D
@torkelsenhus
3 ай бұрын
Yes, I should. They are very expensive I believe?
@inseiin
3 ай бұрын
@@torkelsenhus you are located where? Some cheap ones that can cut about 12mm are in Europe about 200€. But its the max cut. Clean cut is about 6-8mm.
@torkelsenhus
3 ай бұрын
@@inseiin I’m in Europe. Okay, that’s not bad. I’ll have to look into that.
Пікірлер: 12