The power LED on My pumptec is flashing indicating the motor is running but I do not have any water coming from the well pump. Does this imply the pumptec is faulty or the well pump?
@edmundojosemunozjaime7942
Жыл бұрын
I have a pumptec plus. Solid red light and no reset manual.
@susanavargas9259
4 жыл бұрын
Hi, I have a pumptec for a 1 HP motor. Usually I have low voltage problems. How low can I set the sensitivity ?? It is ok to set it in 40%? I am afraid to set it too low and damage the motor.
@richardy98
Жыл бұрын
Hello, I have the subdrive20 installed, is the pumptec recommended to be installed as an extra protection? Are they compatible to be used together?
@RCworstwater
Жыл бұрын
No need. The subdrive has motor protection equivalent to the pumptec built in.
@ejokine1
4 жыл бұрын
Are these compatible with Goulds Submersible pumps? I'm reading mixed reviews about their compatibility with non franklin products. Thanks
@RCworstwater
4 жыл бұрын
As long as the amperage rating of the pump/motor is within range there shouldn't be any issue. Give us a call and we can help you select the right one for the job: 855.329.4519
@todd_p1
5 жыл бұрын
Can I use this to protect an above ground jet pump? I have a low yield well with a jet pump and we run out of water frequently during high demand periods. I'm looking for some way to automatically shut off the pump and this product sounds like it.
@RCworstwater
5 жыл бұрын
You sure can! They work with both submersible and above-ground pumps. The issue with using one on an above ground pump is that it will likely need to be primed if it pumps the well dry, so a simple low pressure cutout switch is usually preferred: www.rcworst.com/square-d-pressure-switch-m4-30-50-psi-w/-low-pressure-cut-off-9013fsg2j21m4.html
@junglesedgeretreats
5 жыл бұрын
hi, I have a submersible pump in my well and would like to have it turn on and off automatically. Which pump dec do you recommend and do I have to pull the pump out of the well and install sensors ? a friend says you have on that does not need sensors down by the bottom of the well
@RCworstwater
5 жыл бұрын
What HP is your pump? It should say on the control box if you have one.
@chowgp
5 жыл бұрын
Hi, is there a pumptec or motor protection device for 10HP motor? I see that pumptec has only up to 5hp motor. Thanks in advance
@RCworstwater
5 жыл бұрын
Yes, we sell a Symcom product that is good for up to 15 HP single phase. It require current transformers as well: www.rcworst.com/SymCom-235P-PumpSaver-Plus-Single-Phase-230v-5-to-15-HP-CT-s-Required-p297.html
Пікірлер: 13