Nice video. Most don't mention the drill bit. I did my '06 road glide the same way, but wanted to find video verification before I took the bike out of the lift. Thanks for sharing.
@rscrod
8 жыл бұрын
if you order the 08d wheels they are a firect fit. This is also 180 rear wheel which is also a direct fit. my bike is a 2003.
@michaelquintana7553
Жыл бұрын
Thank you guys great vid.
@ceec6923
3 жыл бұрын
Forgot the lock washer No lock tight 🤦🏻♂️
@davidvanklinken7138
10 жыл бұрын
very straight forward. Thanks!!
@nickstefano2931
10 жыл бұрын
Thank you very much for the video !
@guyz1970
8 жыл бұрын
are they the stock brake discs from the old wheel?. did you manage to sort the brake rubbing issue out?
@patjholton
8 жыл бұрын
I know you said the rim is an 09 f wheel but what kind of bike ? Cannot find a wheel with 5 1/2 hub. They all seem to be 6 1/2 and don't fit. That wheel looks awesome on there
@bubasknr
12 жыл бұрын
thanks a lot for your videos
@johniboz1
10 жыл бұрын
Thanks. Very helpful but I did not understand what the drill bit was used for.
@phillombardi7978
9 жыл бұрын
To hold back as you make up the nut on the axle.
@speedyspeed8492
8 жыл бұрын
No lock washer for the axle??? I thought it would be washer then put the lock washer on then the axle nut.
@kemosabe2u2
12 жыл бұрын
Thank you for your helpful video.
@edwinsantiago6632
3 жыл бұрын
Why do u use the drill bit?
@evangelosstefadouros1351
Жыл бұрын
Are all motorcycles Same torque specifications
@dustinguriel620
Жыл бұрын
Do you mean 12 FOOT lbs on the pinch bolts!? Not 12 INCH lbs.. that's only ONE foot-lb! Found this while looking for the torque spec... I'm assuming this was just a mistake.
@rscrod
Жыл бұрын
you are correct sir, 11-12 ft/lbs. There is a huge MISPRINT stated 43 to 46 ft/lbs. tighten 2 flats at a time once you are snugged up.
@rogerp6149
5 жыл бұрын
My right side caliper is rubbing the rotor after installation, how can I fix this.
@rscrod
5 жыл бұрын
When tightening the caliper start with bottom bolt first then top. Why did you take off?
@rogerp6149
5 жыл бұрын
I installed a 21 in wheel, then I put on the calipers and the right side caliper scratched the shit out of the rotor and I noticed it grinded down on the upper corners of the caliper itself when I took it back off. I put my stock wheel back on thinking it was the spacing in the new wheel but my stock is doing the same thing. I have a 2008 HD Ultra Classic, do you know if the spacers are the same size and go the same directions of the groove lines on one end of the spacers? Thanks
@jaredstottler1813
3 жыл бұрын
I just did this by myself with no knowledge of how to. Rebuilding motorcyle I am
Пікірлер: 33