1) What are you tapping out of camera that adjust the spindle movement? Or are you turning a screw? 2) Where did you get the tramming aides and how to they work?
@ericx4124
5 жыл бұрын
Where do you get these trimming aids?
@cncshopmill
11 жыл бұрын
Thank you Hoss that really helped me out!
@ja001son
5 жыл бұрын
Because the spindle was already quare to the column on the Y axis you didn't need to do anything... But if you did how do you go about adjusting it?
@gburgs
8 жыл бұрын
Not a whole lot of videos of the Rollie dad method on a mill. Seems to be a good method. You really should lock the z axis when you take your readings at the top and bottom of the Rod. Also don't forget to lock the quill.
@Alannet2008
7 жыл бұрын
Side to side I can get it to zero(balanced to
@mikebergman9336
7 жыл бұрын
Same here alan. After tramming the side to side, I think I'll make some tramming aids. When you go to snug up the head bolts, it likes to twist. No fun. Still trying to figure out how to tram the front to back fade as well.
@ECAstack
8 жыл бұрын
Is it really necessary to tram the spindle to the column using the Rollie dad method first if you have a pro tram tool?
@jetblast7
3 жыл бұрын
I know this is an old video but did anybody come up with a method of adjusting the spindle to column in the Y axis ?
@robbourns2831
2 жыл бұрын
You would have to shim the head to the coloum where it rotates on the column
@TheMudfly80
7 жыл бұрын
Are there any examples of doing this on a RF 45 type mill?
Пікірлер: 12