What position are the cam flats? What oil pump dot is lined up with the crank? Lots of info missing here
@albertodure1001
4 ай бұрын
Excellent video, I just have one question: what position are the cams in? I have a problem with a Cadillac SRX, I can't put it in time and I would like to try this method. Thanks for your help
@angelbatista2416
15 күн бұрын
hi mate. When set the crankshaft according to sprocket marks to oil pump - second position, piston 1 not match to top of dead center. Also piston 2 not exactly match to TDC. I am sure for it, if set the engine timing then your piston 1 must be show TDC. Can be say it, GM timing tools and crankshaft marks not will shown to Piston 1 TDC. Anyone help me?
@user-cv5qb2hd3o
5 ай бұрын
please tell me GMC acadia 3.6 when overclocking, the engine will turn on a little, what could be the reasons.thanks for the answer
@duecedaddy05
3 ай бұрын
Hate to be there when it's time to start it 😂
@ratrodramblin
4 ай бұрын
So you have the flats of all 4 cams up? Preferably with the locking tools? If you can do it this way why do people cycle through the stages? I didnt think about the 2nd stage chain doesnt care where the colored links were but they still seem to line up with the marks.
@IFixCrap2094
2 ай бұрын
Basically stage 1= left side camshafts relaxed. stage 2=right side camshafts relaxed. Follow the stages if you don’t have the locking tools. The stages are used so the camshafts don’t spring while removing the chains on each bank
@AllTerrainAction
4 ай бұрын
Surprised you don’t use any assembly lube on the guides where they meet the chain. Great video though.
@LarsDcCase
4 ай бұрын
Good video.
@rdubya7931
5 ай бұрын
Are the cams in the position that you removed the chains ?
@GSPerformance-mg2wm
4 ай бұрын
Not quite, had to adjust them
@terrencemorris3983
2 ай бұрын
I call 4 shop recently no one wanted to do that job
@navigator185
2 ай бұрын
This is you tube at it's finest. Why show the wrong information. You have to set bank one chain first then you skip the process to show you have to turn the engind slightly to set the bank two chain.
@camarozone2751
2 ай бұрын
I swear almost all the videos literally skips that part
@msmsm0
2 ай бұрын
It is all about cam timing .. you had missed it ....
Пікірлер: 17