loved this i made one a while back out of a 9mm socket drilled through it added set screw but found later i needed a deeper pocket so since i have no ability to cut a square hole in round iron i use 2 inch round stock with a 3/8 pocket i drill pressed into the center and shim the arm bar then tighten set screws like you have beats buying a 4 jaw chuck for the lathe no doubt...........your machines are alwasy super bad ass just like those tunes you rock!!!! thumbs up
@vespremeanu4929
3 жыл бұрын
nicess
@billk6494
10 жыл бұрын
VLAD is Awesome, I have shared a Few of his videos on my Google Plus Page.. Just Perfection...
@19voodoo69
12 жыл бұрын
I need to make a jig like this...
@theinkslave
12 жыл бұрын
I messaged you on facebook, but i will do it here too, this video is fucking awesome, I just recently purchased a lathe (mainly just for binding posts) and REALLY want to make perfect A bars, just wondering where you got that jig that you put the bar stock in? or did you make it? also what kind of tooling were you using to grind the pin down? any help is much appreciated thank you!
@sashadickovski9919
8 жыл бұрын
what material can i use for armature bar?? nice video make this more often
Пікірлер: 8