I bought one of the 29.99 McGraw die grinders this morning. Worked fantastic for the brake job I did today.
@bucky5869
4 ай бұрын
I'm looking to get one of these to clean up/polish the water pump mounting surface on an engine block. As I don't normally use them I'm not looking for upper end. Thanks for the insight.
@JunkworksGarage
4 ай бұрын
👍
@nickmoffett4000
6 ай бұрын
what you said about cheap tools forcing you to be more agile and less agressive is true, makes us better finishers for sure.
@JunkworksGarage
6 ай бұрын
👍
@nativexsoul
4 ай бұрын
what size air compressor would I need to use this tool?
@JunkworksGarage
4 ай бұрын
not sure sorry
@bucky5869
4 ай бұрын
A couple factors to consider with that question. On tools like die grinders you need a lot of air so if you have a single stage compressor with a nominal CFM rate, you'll want a larger tank and allow it to fill completely. If you have a two stage compressor with a higher CFM rating, tank size isn't as important. The lower the CFM, the bigger a tank you'll need. Otherwise you'll only have short bursts of tool runtime and then waiting for the compressor to refill.
Пікірлер: 9