Made one of these and I'm super happy with it. I made sure the preasure is on the end of the limbs and equal. It turns out the angle of my 2 pressing arms is angled like this / \ and not open like this \ /. It ensures the bow doesn't pop out upwards.
@donlucas3462
Жыл бұрын
the way to solve this is simply to strap the bow down so it cant pull up and out
@troym1849
5 жыл бұрын
Nice effort for sure. Always do some research beforehand. You should only be pulling limbs from the furthest point just after the cam bolt. Where you have the wood it’s running almost all the way down the limb which is not good . It will eventually splinter and break
@carlo8308
2 жыл бұрын
I have the exact same bow
@KF1
3 жыл бұрын
Good job.
@MartinMignogna
5 жыл бұрын
It looks off set. The right side limb looks as if the whole limb is pressed onto the wood. It could ruin it's integrity at the pocket like that. Make sure it's pressing from the tips of the limbs or it will ruin them. It will cause fine cracks inside and they will eventually work their way out and catastrophic failure will happen before they even start splintering.
@keithdodson7536
2 жыл бұрын
Nicely thought out but it looks as if its putting pressure on the length of the solid limbs instead of the tips.. But i like your way of thinking.. 👍👍🏹
@fishingolf
6 жыл бұрын
Nice!
@fatalbrett
5 жыл бұрын
not bad m8 cheers
@darnellwatkins4031
6 жыл бұрын
Badass
@vikbon1627
Жыл бұрын
для замены тетивы и тросов , а также настройки , пресс абсолютно не нужен ! - если не хватает знаний и мышления , подскажу , будете удивлены !
Пікірлер: 11