Thanks for posting that! Just picked up an old HRU215 with the two speed and I am determined to get it working again.
@user-xq5gf9gm2f
11 ай бұрын
When I pulled mine apart the gears on the main drive shaft had no gap in between them like yours. I cut the smaller gears weld and re welded onto the bush goes fine now
@gregclaydon6727
9 ай бұрын
Great, so many repair shops don't bother to fix, just replace the box at owners expense
@mattveneri2112
Жыл бұрын
Very helpful video! I did have a question about the needle bearing replacement. How did you remove and install the bearing? Any special tools needed? I believe the bevel pinion gear is traveling too far in when engaging the drive clutch which is causing the grinding sound within the transmission case. I replaced the cable and it did not help. I will also try filing down the aluminum and adding a washer to see if they will help. Thank you!
@gregclaydon6727
9 ай бұрын
So sorry, very slack late reply, been traveling lately... You will need to make up a tool to remove the needle roller bearing, I used a full thread 5/16 bolt with the head shaved a bit, place a large washer on the outside, fit nut and turn with spanner to pull out, I would think a small thrust washer like you mentioned would help too
@jonnoclix7726
4 ай бұрын
Sorry to contact both of you, but I'm looking everywhere. Do either of you have an instruction manual for an Australian-made HRU215 M that I could please buy a photocopy or scan of? I would really appreciate any help in getting a copy of this. Many thanks.
@gregclaydon6727
Жыл бұрын
Bearing Services, but any bearing company should be able to supply, it is a standard size.
@DevonFerguson.
Жыл бұрын
Can you change gear when moving? Assuming just disengage drive and shift then re-engage.
@gregclaydon6727
9 ай бұрын
Usually best to disengage first as the gear is under load
@MartinHappel-wd5zp
6 ай бұрын
Hi looking at a newer Hru 216 self propelled not working, what test can I do on the gear box, turn axles? Thanks in advance
@gregclaydon6727
6 ай бұрын
Not sure on the 216 as I think you would have the 3 speed box? which came out after I retired. Basically check to see if the drive shaft is ok and turning the gearbox shaft, check the the Dog Ratchet in both wheels are engaging ok (common problem) apart from that are your cables ok (not seized) and connected. From here you may have to remove the Gearbox for inspection..best suggestions I can give you without seeing your mower.
@James45792
Жыл бұрын
Where did you buy the roller bearing and oring from?
@gregclaydon6727
Жыл бұрын
Bearing Services, but any bearing company should be able to supply, it is a standard size.
@DIYLifeSkills
9 ай бұрын
I have HR214 that looks very similar to the HRU214. How did you get the adjuster arm brackets removed from the trans shaft? I couldn't do it, so I ended up just breaking and removing the safety shield holding bracket so that I can raise the top trans cover up higher. You can see what I'm talking about at 9:28 mark on this video kzitem.info/news/bejne/wHqjx3mipX13iG0
@gregclaydon6727
6 ай бұрын
Usually not a problem, clean the shaft with a buff and some emery paper, lightly oil and the bearing should slide off ok, I would also replace the hanger bearings as they do wear out quickly. PS Good Video!
Пікірлер: 15