If you enjoyed this video, please consider liking and subscribing so I can produce my content!
Instagram: / theprinthouseyt
Discord: / discord
In this video I walk you though replacing your nozzle and replacing the bowden tube fittings on your 3D printer in order to fix a nozzle that keeps getting clogged. Please leave your comments and suggestions below! :)
0:00 Introduction
1:12 Tighten The Shakey Heat Block
1:25 Remove Excess Plastic Inside Hotend
2:19 Install A New Nozzle
2:44 Replace Bodwen Tube Connectors
7:06 Conclusion
Негізгі бет Тәжірибелік нұсқаулар және стиль How I Fixed My Clogged 3D Printed Nozzle And Rebuilt My Hotend
Пікірлер: 2