BISMILLAH...
My friends, here is a video step by step on how I assemble the R.O 2000 GPD engine using the PA 700 rotoflow pump and the Shimizu PS135 jockey pump.
This R.O engine has 900 watts of electricity, so it is perfect for those of you who have low power but want to have a large capacity RO engine.
This RO machine is equipped with a jockey pump, namely shimizu PS 135bit, and LPS control, the LPS function here is to regulate the on and off of the roto flow booster pump from a very low input water pressure which can be adjusted in the LPS settings so that the Rotoflow pump is always protected from damage, rupture the carbon wheel on the Rotoflow brass head.
This RO 2000 GPS roto flow machine can only use XLP11, XLP, and XULP type membranes, ULP, LP, BE, BW type membranes cannot be installed in this roto flow RO machine.
The following are the specifications and materials needed in assembling this R.O Rotoflow machine:
The frame uses a 20x20mm faceted pipe
Frame dimensions Length x Width x Height: 45cm x 45cm x 125cm
booster pump : Roto flow Dinamo 3/4 hp Vane head : PA 700
Jockey pump: shimizu ps 135 bit
casing membrane 4040
pre filter 2x housing filter 20"
long 2GPM clean water flow meter,
5GPM long dirty water flow meter
Pressure Gauge : 25 bar 1/4"
MCB box : Presto 8 Group
mcb booster pump 4 Amp
Mcb jockey pump 2 amp.
Powell 10A relay contactor
For electricity, please study in my content which discusses the electricity of the R.O engine
Thank you for all your attention, for those who want to participate in building my channel, please subscribe, activate your notification bells, watch the video until it's finished, and give likes, comments and share with all of your friends.
For those who want to donate part of their wealth for the development of my channel, please contact me via WA +6285371113336.
Негізгі бет Тәжірибелік нұсқаулар және стиль HOW TO ASSEMBLE R.O 2000 GPD 900 WATT MACHINE USING THE ROTO FLOW PA 700 PUMP
Пікірлер: 30