Thank you sooooo much...got here by accident, trying to work around a way with normally closed switch... your video saved me a lot of trouble.
@wrinkledasian5206
9 ай бұрын
I really needed this as I was drawing a ladder diagram for class for a water tank with 4 different sensors/depths and kept getting confused. Other videos I watched were so confusing.
@sampathk1212
6 жыл бұрын
Thank you very much. I have two switches that i didnt use because of incompatibility to my application and now i can use them )
@augustmushi5743
4 жыл бұрын
Thank you very much...... Helpful and be blessed
@onetime718
3 жыл бұрын
Thank you very very much...!!!!!!!
@venenareligioest410
2 жыл бұрын
Thank you, those ‘retaining’ clips are called circlips. 👍
@pavankumar9492938028
3 жыл бұрын
Thanks for the solution
@MehmetBoysal
2 жыл бұрын
Good job, thanks.
@mohammedsedki6044
3 жыл бұрын
thanks, it is helpful
@RegmiSudip
6 жыл бұрын
Thank you very much, I was thinking same could be the solution but I was not sure if clip could be reattached or not.
@webpirate22
7 жыл бұрын
I couldn't figure out what was meant by inverting the float. I thought it meant to mount the whole unit upside down which didn't make sense to me. Thanks for the help..
@Agent58Rex
2 жыл бұрын
Totally...I was thinking the same from the title of the video...but still I thought well let's see how tedious it is...turns out it was just a snap...
@PaintSlinger99
2 жыл бұрын
K so I’m using a sump electric float switch in a well reservoir, I need it to on the switch when the tank is low, but usually a sump switch will on the current when the basin is full, so I’m going to get inside this float switch and do what you just did, wish me luck
Пікірлер: 16