Great, but make sure you don't touch the pads with greasy gloves so you don't get contaminant on the pads! (Else they will squeak or not work as well)
@SuperOlds88
2 жыл бұрын
Very good quality video, very clear, no fumbling around like me, no cussing, throwing tools. Thank you for this video, seriously.
@bobcallender8088
23 күн бұрын
Excellent video, thanks that clip was kicking my a@#, I was trying to put it in after the pads , thanks so much.
@AdamAnderson-y2q
4 ай бұрын
Music annoying
@danatool
2 жыл бұрын
Top 👍 but stupid system
@joshuablacklee13
8 жыл бұрын
I'm trying to do this right now but really really struggling to get the pads back in place, I cannot get them to slide back into the caliper. any tips advice?
@TheErsatzMode
8 жыл бұрын
+Joshua Blacklee. The uploader replied to your comment but you probably missed it.
@dongkapuyawn5107
4 жыл бұрын
Cool video! I was skeptical of removing the assembly from the fork on my bike because I might screw up the alignment. I removed the wheel instead for open access during uninstall and cleaning of the brake area.
@거북이라이더-p9z
17 күн бұрын
선생님 아비드 부레이크 패드 교체 영상 감사합니다!
@JonanthonyTarlen
7 ай бұрын
I installed them without draining the brake or even taking it off😂 I was dying but it’s done
@P_double_H
Жыл бұрын
I just bought a used bike to ride around the neighborhood and I found out it came with Juicy 7 brakes.. i didn't even know these brakes were hydraulics... This thing brakes really good.
@eminence_
8 жыл бұрын
I did this, but now they just constantly breaking. Wonder if there is a way to loosen them. They are just way too tight.
@elmakednos
7 жыл бұрын
You have a piston stack case.Go to your mechanic or reset pistons mant times using brake cleaner.
@hamzachetouane969
7 жыл бұрын
greate video, thank u
@metalmorgan
9 жыл бұрын
Thanks!
@jesseespinosa9739
3 жыл бұрын
Didn’t know it took a whole minute to remove bolts jeez
@guarderiakirikoulucia2005
3 жыл бұрын
I had been trying for a long time to know how to change the pad in this type of brakes, and I finally succeeded thanks to you. I thank you very much. Greetings from Spain.
@davidpapp4140
6 жыл бұрын
my pads keep falling out of their place how can i prevent that?
@josedecanyas
3 жыл бұрын
Se ve todo muy claro. Buen trabajo!
@corvus3200
4 жыл бұрын
Best Video, easy to understand....
@garyduran1
Жыл бұрын
Thank you
@carloiannotti8504
3 жыл бұрын
great and clear !
@K0ALA.
4 жыл бұрын
Thanks for the vid! Helped me know what way round the Metal Spring is meant to sit. Cheers
@recordandplayorg
8 жыл бұрын
did you push the pistons back in to the caliper, be sure they are the right way round. push hard, they should click in to place.
@WingsOfADream1
4 жыл бұрын
at the shop we had a tool for this for cars, I'm using a pair of needle nose in reverse but I think I may have a seized piston... the brakes felt like shit and the pads are worn pretty good, not to metal but pretty close, the old pads came out in 3 pieces and I can't get the new ones back in as 1 piece... I kno I could release reservoir pressure and test if it is seized but I fear I would have to bleed it then... My 20/20... when u used the flathead at 1:27 I did the same but I would pry WAYYY harder to fully compress piston... fudge fudge fudge. edit: can't say I recommend it but if you put in 1 pad and tension clip then pry back the clip from the top with a small flathead then ease in 1 side of the remaining pad into the pryed open side then pry the other side and fully insert the pad you can avoid fully depressing caliper pistons... that being said I think my issue may not be only the pads , as the pads are dragging on the disk enough to impact freespin. I will ride it and if it does not work itself out I'm gunna need to bleed it :'( fudge fudge fude x2
@JonanthonyTarlen
7 ай бұрын
@@WingsOfADream1put one in with the clip, take the brace out from the back. Get a mini screwdriver and pull the brake pad holder until you can get the other brake pad into place
@Mr3kites
8 жыл бұрын
Seems a good method, going to try it, cheers thank you.
@trexeater101
3 жыл бұрын
I like how you used gloves 😂
@takecareofyourshoess
2 жыл бұрын
Here's an idea....how about some actual spoken guidance rather than this ridiculously LAME music you've used here?? Would make the video 100X more useful.
@joncrunk598
9 ай бұрын
Here's an idea....how about some appreciation and positive feedback rather than this ridiculously LAME self entitlement you've used here?? Would make the world 1000x more tolerable.
Пікірлер: 30