Thank u for sharing i believe my problem is the same i have a honda cbr 1000 rr 2013 and had the same symptoms it starting to give me the issue of starting on a cold start but after riding it it for a while and turning of it wouldnt start right away i kept using it like that then it completely turned of on me on the road .i got scared though i had seized the engine but rielized it has fresh new oil from last week and i always make sure i have oil .
@josuemarquez2903
28 күн бұрын
My question is does that happen on a bad stators and rectifiers? Does the power and engine turn off wile riding?
@alexdombi-weridetwo
28 күн бұрын
If the stator goes bad the bike will run until the battery voltage drops too low to sustain power and the bike will shut off, yes. If the battery is healthy it will recharge itself somewhat and may allow you to start the bike after sitting off for a while and then the bike will shut off again after the charge is gone. It does sound like you have this same problem, but it's worth verifying the voltage of the bike above idle to see if there's more than 13v to charge the battery while riding.
@glennglenn101
2 ай бұрын
Its a shame you didn't show doing resistance checks on the stator 3 phase plug to ground as this is how they usually fail , to confirm diagnosis and to help others fault finding.
@alexdombi-weridetwo
2 ай бұрын
You're right- a definite miss on my part. Sorry.
@troycrowder9341
2 ай бұрын
where is the link for the parts?
@alexdombi-weridetwo
2 ай бұрын
It's in the description but here you go! Here is the Stator & Regulator/Rectifier kit purchased from Amazon- remember to verify it fits your bike! amzn.to/3Ky6fI1
@shue-moua
18 күн бұрын
Hey, how does he have his Quadlock mount attached? I'm currently using the clutch mount but I don't like it.
@alexdombi-weridetwo
18 күн бұрын
Edited to correct- it's mounted to the bolts the oem stabilizer uses. From quadlock it looks like the flat rectangle two mount plate.
@shue-moua
18 күн бұрын
If you're able to, could you share a photo of it?
@alexdombi-weridetwo
18 күн бұрын
I can't share photos via comments, but if you pause this video at the beginning, you can see it. kzitem.infoDXC0SwQb4gc?feature=share
@shue-moua
18 күн бұрын
@@alexdombi-weridetwo I'm searching for it on quadlock's website, but unable to find it. I'll continue to look and see if I'm able to find something that'll work. Thanks
@alexdombi-weridetwo
18 күн бұрын
@shue-moua I didn't see it listed in the products either but when I did the "build your own" it was listed in the bases.
@javierc2726
2 ай бұрын
Very bad idea to use power tools on fine threaded bolts
@alexdombi-weridetwo
2 ай бұрын
I knew someone would call me out for that :D I get the bolts started by hand and then just the driver to get through the thread and a torque wrench to finish it off. If you mean on the removal, that's a fair point, but as mentioned in the video, I only did it because someone else called me out for only using ratchets on another bike. I seldom actually use power tools. Good to note for others, thanks
Пікірлер: 17