I clean my fuel tanks with rubbing alcohol since it it one of the ingredients I fuel treatment that helps to absorb moisture and is not as much of a mess as gasoline.
@dougsorensen7594
2 жыл бұрын
Never got an answer. Is there a reason you did not remove and inspect the emulsion tube? Thanks
@rogerhensley2164
7 жыл бұрын
Wow. When you didn't have enough light for us to see (and/or focus) , then you put you hand in the area you were pointing to so I couldn't see ANYTHING !!! There was EXTREME close up of one area such that I didn't know where you were since there were no landmarks of anything else that could be seen. I had to replay some areas several times to piece it together and figured out what I needed to know.
@johanh2319
5 жыл бұрын
Great job
@davidcarper5411
Жыл бұрын
"The exit line".. Ok...
@dougsorensen7594
3 жыл бұрын
Is there a reason why you did not remove and inspect the emulsion tube?
@robertweinmann9408
2 жыл бұрын
I have the same carb, which in my case comes off of a 1980's Snapper. On this carb, the emulsion tube is metal and looks to be pressed in. I left mine alone too.
@ospreyassessments4231
4 жыл бұрын
What is the part number for this carburetor? I need to replace one that is beyond repairing.
@tigertruckerman
10 жыл бұрын
Yeah my mistake, there is gasket, a very thin one,i was thinking there must be a normal black one, but there are no holes in bolt
@Purosabor73
10 жыл бұрын
Thanks..nice and clean video.
@tigertruckerman
10 жыл бұрын
Great work, on my carb the brass type bolt on bottom of bowl does not have gasket or hole. Is this right
@Venturi2012
10 жыл бұрын
I've seen those but I'm pretty sure there was still a gasket there.
@franklin5889
9 жыл бұрын
Hi, I have the almost same carburetor of tecumseh premier 3.5 hp. the carburetor is leaking, the o-ring and gasket are very bad and need to be replaced. Please advice me where can I order them. I am not sure if the engine model: SBV 5510 Serial# 1060325 are correct or not. However, when I look at your KZitem, your O-ring and gasket are the same as mine. Please inform me the part number. Thanks.
@mowerrepairshopfortscottkansas
8 жыл бұрын
+Frank Lin Hi Frank If You Got The Model I can get that part if you would like. call me at 785-521-0428
@juanjohnism
7 жыл бұрын
you put the bowl on in the wrong position. the step down side of the bowl goes over the needle hinge pin.
@martinlicht1969
6 жыл бұрын
juanjohnism caught that too...think he meant the "highest side" referring to height of the floor looking inside the bowl..anyway, the roomier inside of the bowl is away from hinge so float can move.
Пікірлер: 16