My Man! You just saved me a couple hundred bucks! I have an Ingersol Rand twin tanks so the breakdown was a little different but the concept was the same. I took off the old gaskets and used fire and smoke caulk instead. Put it back together and Boom! I am back from 0 pressure to 100% Thank you so much.
@louiszkaen3911
Жыл бұрын
You should have tested it for it to work let us see
@pauloribeiro4234
Жыл бұрын
i have the same machine diferent colour , my problem is i can get the eletric motor to start, change to a bigger cap but it turn 2 time than turn off. That cutting switch will arm.
@bevanoneill9448
2 жыл бұрын
Please next time u remove a gasket use a small hammer amd gently tap it loose
@Andkep
Жыл бұрын
Suprised it didnt glue the piston to the head with how much glue went on
@garvielloken3929
6 ай бұрын
Nooice!
@JoeRocket-sf6qs
2 жыл бұрын
Ya didn't show it was not charging then when you "fixed" it you didn't show it was actually fixed and filling the tank.
@ZutiDIY
2 жыл бұрын
To this day im still using it,thanks for watching.
@joebarry1974
Жыл бұрын
All that.... never showed it working.... It could be in the skip for all we know....
@charlessampa3770
Жыл бұрын
Very little air pressure coming from the hose
@kuttmowf
Жыл бұрын
Well maybe it didn't work. He didn't show that part
@ZutiDIY
Жыл бұрын
It worked and still working without any moisture coming out of the hose.
@TheMan-si4iu
Жыл бұрын
@@ZutiDIY Of course it is, you just ran out of memory before you could show it working.
@johnysilver1853
2 жыл бұрын
My compressor starts working and builds pressure up to 150psi but sometimes during work it will not start and won't keep tank charged. Sometimes it turns on only for a few seconds then goes quiet. Sometimes I hears something that it wants to start like air going somewhere through the pipe for a 2 second and then quiets and stays like that. Fails to keep up pressure in tank when I use it. Pressure goes low as 50psi but compressor doesn't start. Then I had to open drain valve to release remaining air pressure in the tank. Disconnect it from AC power for few minutes and it starts working again build up to 150psi again. I don't hear any air leaks. What could be wrong?
@ZutiDIY
2 жыл бұрын
I think you got faulty air pressure control switch.
@johnysilver1853
2 жыл бұрын
@@ZutiDIY Thank you. Its Husky 20 gal 150psi need to check if it can be fixed
@ZutiDIY
2 жыл бұрын
@@johnysilver1853 i m not sure,but you can try to clean its points.
@georgerobson8753
2 жыл бұрын
@@ZutiDIY I agree it does sound like the pressure switch snd they are available on Amazon if Im not mistaken
@ZutiDIY
2 жыл бұрын
@@georgerobson8753 yes,they are available on Amazon.
Пікірлер: 20