Quick question, when the balljoint bolt starts spinning, I just put a c-clamp on it or use a small crowbar to keep tension on it until the bolt seats in the tapered hole. I'm assuming this is an ok approach?
@yorkshireholiday4048
Жыл бұрын
Very good informative video thank you 😊 👍🏼
@cj5312
2 жыл бұрын
Isn’t the lower shock bolt supposed to be oriented with the head of the bolt facing the rear of the car (bolt towards steering rack)?
@beckramsey7746
Жыл бұрын
yes it is.. but i cant imagine it really matters
@miriamvaldes6911
2 жыл бұрын
Thank you very much 👍
@GowsiVideo
5 жыл бұрын
good job
@nopers2223322
4 жыл бұрын
Good shit
@enda0man
5 жыл бұрын
Where did you find the torque specs?
@Chris11249
4 жыл бұрын
I think I always overtighted, since I can't fit my bulky torque wrench in everywhere, but I'd rather do that than too loose lol.
@maxszeles4809
4 жыл бұрын
Do you need the extended tie rods for this install?
@andrewpham168
3 жыл бұрын
@@joeldufkis i have that current set-up but I have so much toe out and not a lot of threads left in the tie rods, any advice?
@zorgain
Жыл бұрын
@@andrewpham168 longer tierods will let you get more toe in, if this is still relative to you lol
Пікірлер: 16