The video will demonstrate how to install carburetors on a 2003 Honda Shadow 1100 motorcycle. Also, the Honda Shadow 1100 was made for multiple years. Hence, the video can help those who own a newer or older Shadow; however, it is your responsibility to check if your motorcycle carburetors are installed similarly. Thank you for watching, and I have included timestamps below.
1. From 00:00 to 01:49, the clamps and carburetor insulators are installed on the cylinder heads.
2. From 01:50 to 03:06, the carburetors are attached to the carburetor insulators.
3. From 03:07 to 04:49, the carburetor insulator clamps are tightened at the cylinder head and carburetor.
4. From 04:50 to 05:04, the rear fuel line is installed to the rear carburetor on the right side of the motorcycle.
5. From 05:05 to 06:23, the choke cable, also known as the starting enrichment cable, is assembled into the right side carburetor.
6. From 06:24 to 06:35, the fuel vapor hose is attached to the connector between the two carburetors facing toward the motorcycle's rear.
7. From 06:36 to 07:15, the fuel feed line is attached to the fitting on the left side carburetor.
8. From 07:16 to 08:03, the left side choke or starting enrichment cable is installed.
9. From 08:-04 to 08:53, the throttle cable bracket is installed.
10. From 08:54 to 11:49, the push and pull throttle cables are hooked up on the motorcycle.
11. From 11:50 to 13:21, the sub-air cleaner is positioned in place, and the clamps are attached.
12. From 13:22 to 13:49, the wiring harness on the left side of the bike and the clutch cable are secured back into their brackets.
13. From 13:50 to 17:35, the air duct is installed, and the clamps are tightened.
14. From 17:36 to 18:49, the crankcase vapor storage tank is installed.
15. From 18:50 to 19:01, the spark plug wire clamp is fastened to the rear cylinder head on the right side of the motorcycle.
16. From 19:02 to 19:36, the coolant overflow hose is routed and hooked onto the radiator.
17. From 19:37 to 22:07, the gas tank is installed, and all hose connections are attached.
18. From 22:08 to 22:30, the front seat is installed.
19. From 22:31 to 24:17, the rear seat cushion is installed.
20. From 24:18 to 25:26, the battery terminals are fastened to the battery.
21. From 25:27 to 26:04, the left side cover is installed.
22. From 26:05 to 28:35, the rear backrest is installed.
Thank you for watching.
Негізгі бет Автокөліктер мен көлік құралдары How to Install Carburetors on a 2003 Honda Shadow 1100 Motorcycle Complete With all Steps Shown
Пікірлер: 4