Greetings, and thank you for visiting my KZitem channel. This video is part two of four videos showing how to install a motor in a 2003 Honda Shadow 1100 motorcycle. At the beginning of the first video, I mention that the video is part one of two, but you can ignore that comment. Due to software issues, I had to split the series into four parts. Finally, this video was posted on January 13, 2024, and not later than January 30, 2024, the rest of the series will be on KZitem. Also, timestamps are included below to help you with your motorcycle repair.
1. From 00:00 to 00:10, the video begins with tightening the upper motor mount bolts, where I stopped in part one.
2. From 00:11 to 00:20, the last subframe bolt is tightened.
3. From 00:21 to 02:09, the left front foot peg and gearshift linkage are installed.
4. From 02:10 to 02:30, the floor jack and engine hoist are removed because they are no longer needed to support the motorcycle.
5. From 02:31 to 04:22, the starter wires are connected.
6. From 04:23 to 07:23, the rear brake linkage, brake pedal, and rear stoplight switch are installed.
7. From 07:24 to 08:37, the horn and rear brake light switch wires are connected.
8. From 08:38 to 09:27, the coolant hose is connected to the front cylinder head.
9. From 09:28 to 12:51, the radiator and all related hardware are installed.
10. From 12:52 to 13:15, the radiator stone chip guard is installed.
Негізгі бет Автокөліктер мен көлік құралдары Part Two: How to Install a Motor in a 2003 Honda Shadow 1100 All Steps Shown in 4k Video
Пікірлер